User manual AEG-ELECTROLUX LAVAMAT 6080 W

[. . . ] The information marked with this symbol provides additional instructions and practical tips on the use of the appliance. Tips and information about economical and ecological use of the machine are marked with the clover symbol. Should any problems arise, this booklet provides instructions on how to solve them by yourself; see section "Something not working?". If this information is not sufficient, please contact our nearest Service centre (address and telephone numbers are indicated on the enclosed leaflet). Printed on recycled paper. [. . . ] Measure out the amount of detergent required and pour it into the main wash compartment . If you wish to perform a prewash, pour detergent also into compartment . Pour the fabric softener into compartment without exceeding the "MAX" mark. Close the drawer, pushing it fully in. C0070 C0071 Select the wash programme and temperature Turn the programme selector dial to the right to the required programme. Turn the temperature selector dial to the required setting. 18 35. 292. 826. . . Lavamat 519 doc. 22/10/2003 10:59 Página 19 How to wash Select the required option(s) Start the programme Pull the programme selector dial outwards: the mains-on light comes on and the programme starts. End of the programme The machine stops automatically. If the anticrease option has been selected, empty out the water before opening the door: - press the anticrease button for a short spin after emptying, or - select the drain programme Push the programme selector dial inward to switch the machine off. Release any buttons which have been pressed. Wait two minutes before opening the door to give the safety locking device time to release. Check that the drum is completely empty, by rotating it manually, in order to avoid any garments left in the drum being damaged (for example shrunk) during a subsequent wash, or their colour running into a subsequent load of laundry. Close the water tap and unplug the appliance. Tighten up the inlet hose. 25 35. 292. 826. . . Lavamat 519 doc. 22/10/2003 10:59 Página 26 Cleaning and maintenance Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: · pull out the plug from the power socket; · close the water tap; · if necessary, wait until the water has cooled down; · open the pump door; · place a bowl on the floor and place the end of the emergency emptying hose into the bowl. The water should drain by gravity into the bowl. When the bowl is full, put the cap back on the hose. Repeat the procedure until water stops flowing out; · clean the pump if necessary as previously described; · replace the emergency emptying hose in its seat after having plugged it; · screw the pump cover again and close the door. The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. · Place the end of the emergency emptying hose and that of the inlet hoses in a bowl placed on the floor and let water drain out. · Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again. · When you intend to start the machine up again, make sure that the room temperature is above 0°C. 26 35. 292. 826. . . Lavamat 519 doc. 22/10/2003 10:59 Página 27 Something not working? If, during the spin cycle, the machine makes an unusual whistling noise, different from the noise made by traditional washing machines, this is due to a new type of motor. If water is not visible in the drum, this is due to the modern technology of new washing machines that use less water than traditional machines. Troubleshooting If a problem arises, you can try to solve it yourself following the instructions below. If you call out an engineer when one of the following problems arises, or to repair a fault due to incorrect use, the call-out will be charged even if requested within the guarantee period. Problem Possible cause Solution The plug is not connected. The door is not properly The machine does not work closed. Insert the plug. Close the door; the click of the lock should be heard. The programme selector Pull out the programme. [. . . ] Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. · The floor surface must be clean and dry, without any wax or polish residue to avoid any possibility of sliding. Do not use viscous substances to move the appliance into place by sliding it across the floor. [. . . ]