User manual AEG-ELECTROLUX LAVAMAT 620

[. . . ] It is essential that this information is observed. This symbol guides you step by step when operating the appliance. . . . 1 3 2 This symbol gives you additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the machine are marked with the clover symbol. [. . . ] (Part no: 899 646 401 5214) Remove rust stains on the drum with a stainless steel cleaning agent. 0 Door 0 Regularly check if there are deposits or foreign bodies in the rubber seal behind the door and remove them. 27 Operating Instructions What to do when 3 The whistling noise when spinning may be different to your prevous washing machine which is due to the modern drive system. Trouble Shooting If you call out an engineer and the fault is listed here, a charge is levied even if the appliance is in guarantee. If the error code (1, (2 or (d is displayed in the multi-display, check the troubleshooting guide below before calling an engineer. After eliminating the error, press the START/PAUSE button. If the error code is displayed again, please contact your local AEG Service Force Centre For all other errors displayed in the multi-display, please contact your local AEG Service Force Centre, stating the error code. Malfunction Possible Cause Remedy Mains plug is not plugged in. Washing machine does Door is not closed properly. START/PAUSE button not pressed long enough. Filter in the threaded fitting Error code (1 appears. Error code (d appears Door is probably not closed properly. Keep START/PAUSE button pressed until the program starts. Unscrew the hose from the tap, remove the filter and clean under running water. When using modular washing powders the individual components were not used in the correct ratio. If there are still grey stains on the washing Washing soiled with ointments, grease or oils was washed with insufficient washing powder. The temperature selected for the wash was too low. A frequent cause is that fabric softener especially a concentrated one has come into contact with the washing. Wash out these types of stains as fast as possible and use the fabric softener carefully. If after the final rinse foam is still visible Modern washing powders can still cause foam in the final rinse cycle. The washing is nevertheless sufficiently rinsed. If there are white residues on the washing These are insoluble contents of modern washing powders. They are not the result of an insufficient rinse. Turn the washing inside out before washing it. Review your choice of powder, possibly use liquid detergents. 31 Operating Instructions Carrying out an Emergency Emptying If the washing machine no longer pumps out the water an emergency emptying must be carried out. [. . . ] Improper repairs may lead to serious risks for the user. 1 46 Installation and Connection Instructions Water Connection 3 The washing machine is provided with safety devices preventing backcontamination of the water supply and complies with local water authority requirements. This appliance is designed to be permanently plumbed into your homes water supply. Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Water Pressure The appliance is designed to operate within the following water pressure limits: minimum 1 bar (14. 5 p. i. ): Unscrew the inlet hose from the appliance at the inlet solenoid valve and remove the flow regulator (to do this, remove the sieve with needle-nose pliers and remove rubber washer behind the sieve). [. . . ]