User manual AEG-ELECTROLUX LAVAMAT 86720

[. . . ] ÖKO-LAVAMAT 86720 update The environmentally friendly washing machine Instruction book Dear Customer, Please read this instruction book through carefully, before using the appliance. Please ensure you fully understand the safety instructions on the first pages of this instruction book!Retain the instruction book for future reference, and pass it on to any future owners. The warning triangle and/or the key words (Warning!, Caution!, Important!), emphasizes information which is important for your safety or the correct functioning of the appliance. [. . . ] Press the door firmly in the area of the lock. 28 Operating Instructions Malfunction Possible Cause The machine is not level. Remedy Adjust the feet according to the installation and connection instruction. Washing machine vibrates during operation or is unstable. There is only very little washing in the machine (e. g. Water could not be completely pumped out prior to spinning because the drain hose is kinked or the drain pump is blocked. Check the drain hose and if necessary remove any kink or clean the drain pump and remove any foreign bodies from the pump housing. Dose detergent exactly in Excessive foaming dur- Probably too much detergent accordance with the manuing the main wash. Threaded fitting on the water inlet hose is leaking. Water runs out from under the washing machine. Fabric softener is not added, compartment À for fabric softener is filled with water. Check the inlet hose and if necessary replace it. Abort the program, remove the washing caught in the door, start a new program. Suction cap in the fabric sof- Clean detergent dispenser tener compartment is not drawer, place suction cap correctly fitted or is blocked. Please contact the AEG Service Force Centre, it has a retro-kit available for pump heights above 1m. Switch off the machine and pull the plug out of the socket, clean the drain pump. Maximum pumping height (drain height 1m from the Washing has not been position of the machine) is spun sufficiently, there exceeded. Drain pump is blocked. The water drainage system is Clean the blockage. blocked. 29 Operating Instructions Malfunction Possible Cause Door is locked due to safety reasons (lamp next to the DOOR/LIGHT button is off). Remedy Wait until the lamp is green. The door cannot be opened with the machine on. Cancel the child safety The child safety device is set. device (see "Child safety device"). Clean filter. The inlet hose filter in the Remnants of detergent coupling of the inlet hose at are building up in the the tap is blocked. The inlet valve filter in the coupling of the inlet hose at the appliance is blocked. . When pressing a program option button the corresponding display does not light up Program progress display flashes continuously. Clean filter. The cause is probably a No negative impact on the detergent with a high silicate rinsing results, possibly use content. The program option selected is not available with the pro- Make another selection. Child safety device is activated; during the washing cycle the program selector was changed. Turn the program selector back to its original position (see "Child safety device"). 30 Operating Instructions If the Washing Results are not Satisfactory If the washing turns greyish and limescale deposits are present in the drum Insufficient washing powder has been added. Program or temperature was not set correctly. [. . . ] Retain the washer for future use. 47 Installation and Connection Instructions Inlet Hose Connection Important!This appliance must be connected to the cold water supply only. The inlet hose provided is 1. 2 or 1. 3 metres depending on the model. If a longer inlet hose is required contact your AEG Service Force Centre. [. . . ]