User manual AEG-ELECTROLUX LAVAMAT PRINCESS 802

[. . . ] This symbol guides you step by step in operating the unit. 2. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentally-responsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". Printed on recycled paper. [. . . ] Pull out the washing detergent drawer as far as it will go. Remove the washing detergent drawer with a firm pull. Remove the softener insert from the middle compartment. Clean the softener insert under running water. 5. Clean the compartments from the rear with warm water. Push on the softener insert as far as it will go so that it is secure. 32 Instructions for use 7. Use a brush to clean the entire rinsing-in part of the washing machine, especially the nozzles on the top side of the rinsing-in chamber. 8. Insert the washing detergent drawer into the guide rails and push it in. Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Our Customer Service Department has suitable agents available. Disconnect Filter in the socket of the inhose from water tap, remove flow hose connection is filterand clean under blocked. Check water tap, if necessary have it repaired. 35 Instructions for use Problem Possible cause Transport safeguard has not been removed. The height adjustable threaded feet are not correctly adjusted. Remedy Remove transport safeguard according to setting up and connection instructions. Align feet according to setting up and connection instructions. Washing machine viThere is very little washing in brates during operation the drum (e. g. only a dressing Function is not affected by this. Water could not be fully pumped out before spinning because drainage hose is kinked or water pump is blocked. Wash water of the mainwashing foams strongly. Probably too much washing agent has been filled in. Connection to the inflow hose is leaking. Cover of the water pump is not properly closed. [. . . ] Water Drainage into a Siphon The grommet on the end of the hose fits all commonly used siphon types. Secure the grommet/siphon connecting point with a hose clamp. 0 Draining the water into a basin Attention!­ Small basins are not suitable for draining the water into them. ­ It is not permitted to submerge the end of the drainage hose into the pumped-off water. [. . . ]