User manual AEG-ELECTROLUX LAVAMAT REGINA 804U

[. . . ] This symbol guides you step by step in operating the unit. 2. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentally-responsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". [. . . ] Use warm water to do this. 0 Washing Detergent Drawer The washing detergent drawer should be cleaned from time to time. Pull out the washing detergent drawer as far as it will go. Remove the washing detergent drawer with a firm pull. Remove the softener insert from the middle compartment. Clean the softener insert under running water. 5. Clean the compartments from the rear with warm water. Push on the softener insert as far as it will go so that it is secure. 29 Instructions for use 7. Use a brush to clean the entire rinsing-in part of the washing machine, especially the nozzles on the top side of the rinsing-in chamber. 8. Insert the washing detergent drawer into the guide rails and push it in. Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Check the condition of the outlet hose, and straighten any kinks or folds, or clean the detergent solution pump, removing any foreign bodies from the pump casing if required. Follow precisely the manufacturer's instructions on the amount of detergent to use. 32 Instructions for use Fault Possible Cause Remedy The water inlet hose coupling Tighten the hose coupling. Check the outlet hose and replace if necessary. The detergent solution pump Close the cover properly. Stop the programme, remove the item from the door. Fasten the emergency drain hose correctly (see "Carrying out an emergency drain operation"). If the emergency drain hose is loose, contact Customer Service. Clean the detergent dispenser drawer, set the fabric softener tray firmly in position. Note the maximum wash load (see Programme tables). For easy-care textiles, select the EASY IRON (STRIJKVRIJ, SANS REPASSAGE) programme. The emergency drain hose is not properly fastened or is loose. Fabric softener is not drawn in, the conditioner æ compartment is full of water. The fabric softener tray in the conditioner compartment is not correctly positioned, or is clogged. Clothes are severely crumpled. Too much washing has probably been loaded. The washing has not been spun as dry as usual. The washing was not able to Always load the drum as ful be distributed evenly in the as possible with a combinadrum prior to spinning. tion of large and small items. 33 Instructions for use Fault Possible Cause There is a kink in the outlet hose. Washing is not spun sufficiently, excess water is still visible in the drum. [. . . ] In the event of legally admitted liability, compensation will not exceed the purchase price paid for the appliance. These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. For appliances purchased abroad, the user must first ensure that they meet the qualifications required in Belgium. [. . . ]