User manual AEG-ELECTROLUX LAVAMAT107TURBO

[. . . ] This symbol guides you step by step through the operation of the appliance. . . . 3 2 This symbol gives you additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the machine are marked with the clover leaf. In the event of a malfunction, these operating instructions contain information on how to remedy these faults yourself. [. . . ] Wipe over the operating panels with a damp cloth. Use warm water. 0 Detergent Dispenser Drawer The detergent dispenser drawer should be cleaned from time to time. Pull the detergent dispenser drawer out as far as it will go. Remove the detergent dispenser drawer by pulling sharply. Take the conditioner insert out of the middle compartment. Clean the conditioner insert under running water. 5. Clean the separate compartments with warm water. Push on the conditioner insert as far as it will go so that it is securely in place. 26 Operating Instructions 7. Use a brush to clean the entire compartment area of the washing machine, particularly also the nozzles on the top side of the compartment. 8. Set the detergent dispensing drawer into the guide tracks and push it in. Washing Machine Drum The washing machine drum is made from rust-free stainless steel. Any objects left in the laundry which are likely to rust can stain the drum. under running water. It may be necessary to reduce the amount of deterExcessive foaming dur- Probably too much detergent gent used. was used gent manufacturer's recommendations. 29 Operating Instructions Problem Possible Cause The transport packaging has not been removed. Remedy Remove transport packaging according to the installation and connection instructions. Adjust the feet according to the installation and connection instructions. The machine is not level. The washing machine vibrates during operation or is unstable. There is very little washing in This does not impair the the drum (e. g. The water could not be completely pumped out before spinning because the drain hose is kinked or the drain pump is blocked. Check the drain hose and remove any kink if necessary, or clean the drain pump and, if required, remove foreign bodies from the pump housing. The screw connection on the Tighten the inlet hose screw inlet hose is leaking. connection The drainage hose is leaking. The drain pump cover is not correctly closed. Water runs out from under the washing machine. Check the drainage hose and replace it if necessary. [. . . ] the customer´s home, place of installation or AEG workshop). The guarantee or free replacement includes both labour and materials. Repairs carried out under guarantee do not extend the guarantee period for the appliance. Parts removed during guarantee repairs become the property of AEG. [. . . ]