User manual AEG-ELECTROLUX LAVATHERM 323 D

[. . . ] This symbol guides you step by step through the operation of the appliance. . . . 3 2 This symbol gives you additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the machine are marked with the clover leaf. In the event of a malfunction, these operating instructions contain information on how to remedy these faults yourself. [. . . ] Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee. · If the fault code C1 or C2 is shown in the multi-display, you may be able to remedy the fault yourself (see the Fault table below). When you have remedied the fault, press the START/PAUSE button. · With all other displayed faults (C plus number or letter): switch appliance off and on again. Reset the wash programme and press the START/PAUSE button. If the fault code is displayed again, please contact the Customer Service department quoting the fault code. Problem Possible cause The mains plug is not plugged in. Washing machine does Door is not properly closed. Close door; Lock must engage audibly . Keep the START/PAUSE butSTART/PAUSE button has not ton pressed until the probeen pressed long enough. Cancel child safety feature (see section , , Child safety feature"). Disconnect Filter in the socket of the inhose from water tap, remove let hose connection is filter and clean under blocked. Water tap is blocked with limescale or is faulty. Drain pump is blocked. At the siphon connection: SiClean siphon. The door is locked for safety Wait until the DOOR/LIGHT reasons (DOOR/LIGHT display display lights up green. Cancel programme security (see section , , Programme protection"). The door cannot be opened when appliance is switched on. The programme security function is On. 34 Operating Instructions Problem Possible cause Water tap is not fully opened. Remedy Open water tap fully. Remnants of detergent Close the water tap. Unscrew are building up in the The inlet hose filter in the the inlet pipe from water tap detergent drawer. coupling of the inlet hose at and from the appliance and the tap is blocked. The cause is probably a detergent with a high silicate content. No negative influence on the rinse results, use a liquid detergent if necessary. When pressing a proThe selected programme opgramme option button tion cannot be combined Make another selection. the corresponding diswith the set programme. Programme security is switched On; the proProgramme cycledisgramme selector has been play flashes constantly. [. . . ] · All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. · This guarantee is in addition to your statutory and other legal rights. · Home visits are made between 8. 30am and 5. 30pm Monday to Friday. [. . . ]