User manual AEG-ELECTROLUX LAVATHERM ELECTRONIC

[. . . ] This symbol guides you step by step through the operation of the appliance. . . . 3 2 This symbol gives you additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the machine are marked with the clover leaf. In the event of a malfunction, these operating instructions contain information on how to remedy these faults yourself. [. . . ] Close the emergency emptying hose and place it in the holder. Close the flap. 29 Operating Instructions What to do if. . . Trouble Shooting If the appliance is not working correctly, please carry out the following checks before contacting your local AEG Service Force Centre. Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee. · If the fault code E10, E20 or E40 is shown in the multi-display, you may be able to remedy the fault yourself (see the Faults table below). After clearing the fault, press the START/ PAUSE button. If the fault code is displayed again, contact your local AEG Service Force Centre. · For all other faults displayed in the multi-display, please contact your local AEG Service Force Centre, stating the fault code. Problem Possible Cause The mains plug is not plugged in. START/PAUSE button not pressed long enough. Close the door; The lock must engage audibly. Keep the START/PAUSE button pressed until the programme begins. Cancel the child safety feaDoor cannot be closed. The child safety feature is set ture (see Section "Child Safety Feature"). Contact your local Service Force Centre. For pumping heights over 1m a conversion kit is available as a special accessory. Switch off the appliance and pull out the mains plug. Clean the drain pump. The emergency emptying hose is not correctly closed or is leaking. Fabric softener was not washed in, compartment æ for conditioners is filled with water. The conditioner insert in the compartment for the conditioners is not correctly attached or is blocked. Washing heavily creased Probably too much washing put in the drum. Drain hose is kinked. Water is Maximum pump head (discharge height 1m from the left in the drum. Drain pump is blocked. 32 Operating Instructions Problem Possible Cause Remedy Wait until the DOOR display lights up green. If it is still necessary to open the door: The door is locked due to a turn the programme selector high water level or a high temperature. (the DOOR dis- to OFF turn the programme selector to PUMP OUT. the START/PAUSE button After the water has been pumped out, the door can be opened. If water can be seen through the window in the door, first carry out emergency emptying (see section "Carrying out Emergency Emptying Operation"). 4 to 5 minutes the door can be opened again by pulling the handle. [. . . ] 16 Olympiysky prospekt 129090 Moscow Tel. : (095) 937 7837 Fax: (095) 926 5513 52 Warranty conditions Israel Electricity & Electronic Services-Evis LTD. Raanana, Industrial area 43654 Tel: 972-9-7448118 Fax: 972-9-7603618 e-mail:evis@evis. co. il Malaysia Arzbergh Engineering No. 49A/B, Jalan Petaling Utama 7 4600 Petaling Jaya Tel. : 3 795 1084 Fax: 3 795 1082 Saudi Arabia Alia Trading Corporation P. O. Box 4101 King Abdul Aziz Street Riyadh Tel. : 4645977 Al Nahas Est. [. . . ]