User manual AEG-ELECTROLUX LAVBELLA 1000

[. . . ] Switching on the appliance/ selecting a programme. Changing the spin speed/selecting rinse hold . Interrupting a programme/adding washing . End of the wash cycle/removing the washing . [. . . ] Do not clean the drum with acidic descaling agents, scouring agents containing chlorine or iron or steel wool. Remove any rust deposits on the drum with a cleaning agent for stainless steel. Run a washing cycle without any washing to clean off any cleaning agent residues. Programme: COTTONS/LINEN 60, press QUICK WASH button, add approx. 1/4 of a measuring cup of washing powder. Door and rubber collar Regularly check whether deposits or foreign bodies are present in the folds of the rubber collar or on the inside of the glass door. Clean the glass in the door and the rubber collar regularly. 19 What to do if. . . Remedying small malfunctions If one of the following fault codes is displayed in the multi-display during operation: ­ E10 (Problems with water inlet), ­ E20 (Problems with water drainage), ­ E40 (door open), please have a look at the following table. When the fault is remedied, press the START/PAUSE button. In the event of other faults (E plus a number or a letter): Switch the appliance off and on again. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault code. Problem Possible cause Mains plug not plugged in or fuse not working. START/PAUSE button was not pressed for long enough. Please contact the Customer Care Department. Remove foreign bodies from pump housing. Clean out sink outlet. 21 Problem Conditioner not rinsed in, w compartment for additives is filled with water. Possible cause Conditioner insert in the compartment for additives is not correctly attached or is blocked. Door locked. Remedy Clean detergent dispenser drawer, insert conditioner insert firmly. Programme continues, when power cut is over. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. Door cannot be opened Power cut. (All display indiwhen appliance is cators are off. ) switched on. Door remains locked for 4 to 10 minutes. Washing is heavily creased. Possibly too much washing was loaded. If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum · Too little detergent is being used. · The right detergent was not used. · Special soiling was not pre-treated. [. . . ] Only original hoses may be used to extend hoses. (A maximum of 3 m laid on the floor and then 80 cm vertically). The Customer Care Department stocks outlet hoses of different lengths. Draining water into a sink outlet Secure the outlet/sink outlet joint with a hose band clip (available from your dealer). 1 Draining water into a wash basin/bath Important! [. . . ]