User manual AEG-ELECTROLUX LAVBELLA3251

[. . . ] LAVAMAT BELLA 3251 Washing machine User information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions. [. . . ] Always load the drum as full as possible. Mix large and small items. Washing has not been spun. Screw connection on the inTighten inlet hose. Water is leaking out un- Drain pump cover is not derneath the washing closed properly. END indicator flashes 15x, at the same time an acoustic The Aqua Control anti-flood signal sounds 15x. The drain pump runs constantly, even when the machine is switched off. At the Probably too much deterend of the washing cygent has been used. END indicator flashes 2x, at the same time an acoustic signal sounds Drain pump is blocked. (Problems with water outflow. ) With connection to sink outlet: sink outlet is blocked. Load washing carefully for the next wash. Close off emergency drain hose properly. Turn off the tap, remove the mains plug from the socket and contact the Customer Care Department. Dose detergent exactly as instructed by manufacturer. Remove kink. Please contact the Customer Care Department. Remove foreign bodies from pump housing. Clean out sink outlet. 21 Problem Conditioner not rinsed in, w compartment for additives is filled with water. Possible cause Conditioner insert in the compartment for additives is not correctly attached or is blocked. Door locked. Remedy Clean detergent dispenser drawer, insert conditioner insert firmly. Programme continues, when power cut is over. To remove washing: If water can be seen in the appliance, before opening the door, first drain off the water. (See section "Carrying out an emergency drain". ) Observe maximum loads. Door cannot be opened Power cut. (All display indiwhen appliance is cators are off. ) switched on. Door remains locked for 4 to 10 minutes. Washing is heavily creased. Possibly too much washing was loaded. If the wash results are not satisfactory Washing is grey and scale is being deposited in the drum · Too little detergent is being used. · The right detergent was not used. · Special soiling was not pre-treated. · Programme or temperature was not correctly set. [. . . ] Otherwise water could be sucked back into the appliance. ­ When draining into a wash basin or a bath, secure the drain hose with the supplied elbow to stop it slipping. Otherwise the water running out can force the hose out of the basin. ­ When pumping the water out, check that the water is running away fast enough. Pumping heights over 1 m The washing machine's drain pump is able to pump water to a height of 1meter, calculated from the surface on which the appliance is installed. [. . . ]