User manual AEG-ELECTROLUX LAVR2550F

[. . . ] LAVAMAT REGINA 2550 F update The Environmentally-Friendly Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] Reset the wash programme and press the START/PAUSE (START/PAUSE, MARCHE/PAUSE) button. If the fault code is displayed again, please contact the Customer Service department quoting the fault code. Problem Possible cause Electric plug not inserted. Remedy Insert electric plug. Fuse of the mains installation Replace fuse. Washing machine does Door is not properly closed. Button: START/PAUSE (START/PAUSE, MARCHE / PAUSE) has not been pressed long enough. Press START/PAUSE (START/ PAUSE, MARCHE /PAUSE) button until the programme starts. Cancel child safety feature (see section , , Childsafety feature"). 35 Instructions for use Problem Possible cause Water tap is switched Off Water is not entering. Remedy Open water tap. Close water tap. Disconnect Filter in the socket of the inhose from water tap, remove flow hose connection is filterand clean under blocked. Transport safeguard has not been removed. The height adjustable threaded feet are not correctly adjusted. Check water tap, if necessary have it repaired. Remove transport safeguard according to setting up and connection instructions. Align feet according to setting up and connection instructions. Washing machine viThere is very little washing in brates during operation the drum (e. g. only a dressing Function is not affected by this. Water could not be fully pumped out before spinning because drainage hose is kinked or water pump is blocked. Wash water of the mainwashing foams strongly. Probably too much washing agent has been filled in. Move the path of the hose and, if necessary, remove kink or clean water pump and, if necessary, remove foreign body from pump housing. Dose washing agent exactly according to manufacturers instructions. 36 Instructions for use Problem Possible cause Connection to the inflow hose is leaking. Cover of the water pump is not properly closed. Check drainage hose and, if necessary, replace. [. . . ] For delivery heads over 1m, consult the Customer Service. Technical Data Height adjustment Filling quantity (program-dependent) Use Drum speed, spin Water pressure Approx. 5kg Domestic see rating plate 1-10bar (=10­100N/cm2 = 0. 1­1. 0MPa) Dimensions (Measurements in mm) 58 Customer Services Customer Services Schweiz - Suisse - Svizzera A + T Hausgeräte AG Kundendienst AEG Industriestraße 10 5506 Mägenwil Service Eine Tel. -Nr. für die ganze Schweiz ServicePhon 0848 848 348 Fax 062/889 95 85 Ersatzteildienst Ersatzteilverkauf ganze Schweiz Telefon 0848 848 028 Fax 062/889 94 90 Regionalbüro Westschweiz: 1028 Préverenges Le Trési 6, Verkauf Tel. 021/803 24 15 Fax 021/803 25 24 Regionalbüro Tessin: 6616 Losone Centro Montana Verkauf Tel. [. . . ]