User manual AEG-ELECTROLUX REGINA 2651

[. . . ] Washing machine User information Swissline GL EWF 1182 132 978 540-00-090806-01 g Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Operating Instructions . [. . . ] END indicator flashes 4x, at the same time an acoustic signal sounds 4x. Door is not closed properly. Close door properly. Start programme again. 19 Problem E10 appears. END indicator flashes 1x, at the same time an acoustic signal sounds 1x. (Problems with water inflow. ) Washing machine vibrates when operating or is noisy. Possible cause Tap turned off. Filter in the screw connection of the inlet hose is blocked. Water tap is blocked with limescale or faulty. Only a few large items of washing in the drum. Screw connection on the inlet hose is leaking. Drain hose is leaking. Remedy Turn the tap on. Unscrew hose, take out filter and clean it. Check the water tap and have it repaired if necessary. Adjust feet according to the Installation and Connection instructions. Always load the drum as full as possible. Load washing carefully for the next wash. Washing has not been spun. Drain pump cover is not Water is leaking out underneath the washing ma- closed properly. Washing was caught in the door. Emergency drain hose is leak- Close off emergency drain hose ing. END indicator flashes 15x, at the same time an acoustic The Aqua Control anti-flood signal sounds 15x. The drain pump runs constantly, even when the machine is switched off. At the end of Probably too much detergent the washing cycle, the has been used. OVER DOSING indicator is lit. Turn off the tap, remove the mains plug from the socket and contact the Customer Care Department. Dose detergent exactly as instructed by manufacturer. 20 Problem Possible cause Kink in the drain hose. Remedy Remove kink. Please contact the Customer Care Department. Remove foreign bodies from pump housing. Maximum pumping height of E20 appears. END indicator flashes 2x, at the same time an acoustic signal sounds Drain pump is blocked. [. . . ] If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system. There should be a minimum distance of 5. 02m (16. 5 ft) between the appliance's inlet and the bottom of the water storage tank. Aqua Control The inlet hose is provided with a water stop device, which protects against damage caused by water leaks in the hose which could develop due to natural ageing of the hose. This fault is shown by a red sector in the window , , A". Should this occur, turn the water tap off and refer to your Service Centre to replace the hose. 31 Water drainage The maximum permitted difference between the height of the surface on which the appliance is installed and the water outlet is 1 metre. [. . . ]