User manual AEG-ELECTROLUX LAVTHT30

[. . . ] Conduite d'évacuation d'air pour appareils installés en série . 27 28 29 32 Avvertenze sulla sicurezza . 33 Servizio senza condotto dello scarico aria . 34 Servizio con condotto di scarico dell'aria . [. . . ] 48 49 50 53 4 1 Important Safety Information · Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. · This tumble dryer is designed to be vented through to the open air. It should have its own ventilation system which should not be joined with any other ventilation system connected to any other appliance. · The dryer must not be vented into a chimney, or flue pipe designed to carry the exhaust from a fuel burning heating appliance. · If the tumble dryer is installed next to fuel burning stove, a heat insulation non-flammable pad must be inserted between the fuel burning stove and the tumble dryer: (dimensions 85 x 57 cm). · If the dryer is installed in a room with a fuel burning heating appliance, consult your local Corgi registered installer. · The tumble dryer should not be installed in situations which may be subject to freezing temperatures. · The installation site must be well ventilated. · Ensure the appliance does not stand on the electrical supply cable. · If the machine is situated on carpeted floor, please adjust the feet in order to allow air to circulate freely. · The tumble dryer must be level. · Observe the safety precautions in the operating instructions for your dryer. 12 Installation Site Preparation · The installation surface must be clean and dry. · Do not install on a deep pile carpet. · If the appliance is installed next to a heat source (e. cooking appliance), a heat insulation pad (85 x 57 cm) must be placed between the washing machine and the heat source. · Do not install the appliance where the temperature may fall below freezing or rise above 35°C. · Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. Levelling the Appliance The appliance must be levelled using the adjustable feet. Use a screwdriver to adjust to the feet until the appliance is level. 13 Venting Venting The appliance expels hot, moist air which must be able to flow freely from the tumble dryer vent. Tumble Dryer Vents View from left Rear view View from right The most efficient way of venting the expelled air is via a vent hose through to the outside. 14 Venting Venting through a Vent Hose The vent hose expelling the hot air should be 100 mm diameter and no longer than 4 meters. [. . . ] Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is located inside the door. The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1362) fuse must be used. Should the plug need to be replaced for any reason. [. . . ]