User manual AEG-ELECTROLUX LAVW1010-W

[. . . ] · Ensure all packaging and transit bolts/bar have been removed, see , , Removing of Transit Packaging". Failure to remove packaging and transit bolt/bar may cause serious damage to the product or property. · Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. [. . . ] · Do not install the appliance in locations where the temperature may fall below freezing. · Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. Installation on a Suspended Floor Suspended wooden floors are particularly susceptible to vibration. To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws. If possible install the appliance in one of the corners of the room, where the floor is more stable. Levelling the Appliance · The appliance must be levelled using the adjustable feet. · Adjust the feet using the spanner provided. · Ensure the spanner is securely pushed onto the hex head on the feet of the appliance. · Adjust the feet so that the appliance is level. The appliance must not rock when weight is applied. · Check the appliance level using a spirit level. · Never use strips or shims of wood or cardboard etc to compensate for any uneveness in the floor. Always use the adjustable feet. Self Adjusting Foot Appliances with a spin speed of 1400 r. and over have a self adjusting foot fitted (rear right). · If the appliance vibrates or is unstable during a spin cycle of 1400 r. m. : Set the three adjustable feet to length of 10 mm. · If the self adjusting foot (rear right) does not reach the floor: Manually extend the self adjusting foot to the required length. 19 Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. 1 WARNING - THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. [. . . ] Retain the washer for future use. Inlet Hose Connection The inlet hose provided is 1. 2 or 1. 3 metres depending on the model. If a longer inlet hose is required contact your AEG Service Force Centre. Under no circumstances should hoses be connected together to provide a longer length. [. . . ]