User manual AEG-ELECTROLUX LAVW1047

[. . . ] LAVAMAT Princess 5250 Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] Pull out the washing detergent drawer as far as it will go. Remove the washing detergent drawer with a firm pull. Remove the softener insert from the middle compartment. Clean the softener insert under running water. 5. Clean the compartments from the rear with warm water. Push on the softener insert as far as it will go so that it is secure. 26 Instructions for use 7. Use a brush to clean the entire rinsing-in part of the washing machine, especially the nozzles on the top side of the rinsing-in chamber. 8. Insert the washing detergent drawer into the guide rails and push it in. Washing Drum The washing drum is made of high-quality stainless steel. Rust deposits on the drum can occur due to foreign bodies in the washing which can cause rust. Do not clean the stainless steel drum with acidic antiliming agents, scouring agents containing chlorine or iron or steel wool. Our Customer Service Department has suitable agents available. Remove any rust deposits on the drum using a stainless steel cleaning agent. 0 Filling Door 0 Check regularly whether there are deposits or foreign bodies in the rubber sleeve behind the filling door and, if so, remove them. 27 Instructions for use What to do if . . . Remedying Faults In the event of a fault, try to solve the problem yourself with the aid of the information provided here. If you call Customer Service to deal with one of the faults listed here or to remedy an operating fault, the customer service technician's visit will not be free of charge, even during the warranty period. Problem Possible Cause The power plug is not connected. The START/PAUSE (START/ PAUSE, MARCHE/PAUSE) button was not pressed for long enough. The END (ENDE, FIN) indicator flashes 4 times. Remedy Connect the plug to a power outlet. Close the door; there should be an audible click. Press and hold the START/ PAUSE (START/PAUSE, MARCHE/PAUSE) button until the programme starts. Release the child safety device (see section "Child safety feature"). Re-start the programme. The END (ENDE, FIN) indicator flashes once. Switch off the washing machine: Close the water tap. Remove The filter in the threaded inthe plug from the mains, unlet hose fitting is blocked. screw the hose from the water tap, take out the filter and wash it in running water. [. . . ] Fix the elbow to the water tap or to the wall with string. 0 46 Setting up and connection instructions Delivery Heads over 1m To pump off the washing / rinsing agent, every washing machine has a pump which transports liquids via the drainage hose up to a height of 1m, calculated from the machine's floor. For delivery heads over 1m, consult the Customer Service. Technical Data Height adjustment Filling quantity (program-dependent) Use Drum speed, spin Water pressure Approx. 5kg Domestic see rating plate 1-10bar (=10­100N/cm2 = 0. 1­1. 0MPa) Dimensions (Measurements in mm) 47 Customer Services Customer Services Schweiz - Suisse - Svizzera A + T Hausgeräte AG Kundendienst AEG Industriestraße 10 5506 Mägenwil Service Eine Tel. -Nr. für die ganze Schweiz ServicePhon 0848 848 348 Fax 062/889 95 85 Ersatzteildienst Ersatzteilverkauf ganze Schweiz Telefon 0848 848 028 Fax 062/889 94 90 Regionalbüro Westschweiz: 1028 Préverenges Le Trési 6, Verkauf Tel. [. . . ]