User manual AEG-ELECTROLUX LAVW1449

[. . . ] LAVAMAT W 1450 ELECTRONIC Washing Machine User Information Dear customer, Please read this user information carefully. In particular, pay attention to the section "Safety" on the first pages. Keep this user information in a safe place for later reference. Pass it on to any subsequent owners of the unit. 1 Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). [. . . ] Release the child safety device (see section "Child safety feature"). The door is not closed properly. Close the door properly. Re-start the programme. 30 Instructions for use Problem Possible Cause The water tap is closed. Re-start the programme. The END (FIN/EINDE) light flashes once and at the same time an acoustic signal sounds once. Switch off the washing machine: Close the water tap. Remove The filter in the threaded inthe plug from the mains, unlet hose fitting is blocked. screw the hose from the water tap, take out the filter and wash it in running water. Water tap is furred with limescale or faulty. Check the water tap and have it repaired, if necessary. First turn the programme selector to OFF (ARRET/UIT), then set the desired programme to the exact position. Remove the transit bolts/bars as described in the Installation and Connection instructions. Adjust the screw feet as described in the Installation and Connection instructions. The END (FIN/EINDE) light flashes 8 times and at the same time an acoustic signal sounds 8 times. The programme selector has not clicked into place correctly. The transit bolt/bars were not removed. The height-adjustable screw feet have not been set correctly. The washing machine vibrates when operating or is noisy. There is very little washing in Operation is not affected by the drum (for example, only this. Water could not be drained completely before spinning, because the outlet hose has got a kink in it or the drain pump is blocked. Check the positioning of the outlet hose and even out any kinks if necessary or clean the drain pump and remove any foreign matter that might be in the pump housing. The main wash deterFollow the manufacturer's Probably too much detergent gent solution produces instructions exactly, when was used. measuring out detergent. 31 Instructions for use Problem Possible Cause The threaded inlet hose fitting is not watertight. Remedy Screw the inlet hose in firmly. The outlet hose is not water- Check the outlet hose and tight. The drain pump cover is not closed properly. Water runs out from under the washing machine. Close the cover properly. Stop the programme and Washing has been trapped in free the washing from the the door. Connect the emergency drain hose properly (see Section "Emergency Drain Procedure"). If the emergency drain hose is leaking, call Customer Service. Clean the detergent drawer, adjust the conditioner insert firmly. [. . . ] These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances, the user must first make sure that they satisfy the technical conditions (e. g. : voltage, frequency, installation instructions, type of gas, etc. ) for the country concerned and that they can withstand the local climatic and environmental conditions. For appliances purchased abroad, the user must first ensure that they meet the qualifications required in Belgium. Non-essential or requested adjustments are not covered by the guarantee and are not possible in all cases. [. . . ]