User manual AEG-ELECTROLUX LAVW850

[. . . ] LAVAMAT W 859 ELECTRONIC Washing Machine User information Dear Customer, Please read this user information carefully. Pay particular attention to the section "Safety" on the first Info pages. Please keep this user information in a safe place for later reference. Pass it on to any future owners of the unit. 1 The warning triangle and /or signal words (Warning!, Caution!, Important!) emphasise information which is important for your safety or for the unit's functional reliability. [. . . ] Follow the detergent manufacturer's recommendations. Tighten the inlet hose screw connection. Check the drainage hose and replace if necessary. Close the cover correctly. Probably too much detergent has been used The screw connection of the inlet hose is leaking. The drain pump cover is not correctly closed. Water leaks out Stop the programme, remove of the washing maWashing is caught in the door. Close the emergency emptying hose (see Section "Carry The emergency emptying hose out emergency emptying"). is not correctly closed or is Call your local Service Force leaking. Centre if the emergency emptying hose is leaking. Fabric softener was The insert in the conditioner not rinsed in, the compartment is not correctly compartment is attached or is blocked. Clean the detergent dispenser drawer and attach the conditioner insert correctly. 29 Operating Instructions Problem Possible cause Remedy Pay attention to the maximum load quantity (see Programme Tables). In the case of easycare fabrics, select the < (EASY IRON) programme. Always load the drum as ful as possible with a combination of large and small items. Contact your local Service Force Centre. For pumping heights over 1 m a conversion kit is available as a special accessory. Switch off the machine and disconnect the mains plug. Wait until the programme has ended, the K (DOOR) light goes off and the L (END) light is lit. If it is necessary to open the door immediately, Turn the programme selector to I (OFF); then turn it to v (DRAIN). When the water has been pumped out, the door can be opened. Washing is heavily creased. Probably too much washing has been put in the drum. The washing has not been spun as dry as usual. The washing was not able to be distributed evenly in the drum prior to spinning. The maximum pump height (outlet height 1 m from the base of the appliance) is exceeded. Washing is not thoroughly spun, water remains visible in the drum. The indicator L (END) flashes twice. The drain pump is blocked. For siphon attachments: the siphon is blocked. The door cannot be opened when the washing machine Door is locked due to high is on. water level, or high temperaO/s (START/ ture. [. . . ] 1142 Budapest Tel. : 00361/467-3200 Singapore Arzbergh Engineering 19 Tanglin Road 06-07 Singapore 247909 Tel. : 65 7356572 Fax: 7351124 Slovakia Rep. Seberiniho 1 821 03 Bratislava Tel. : 02 4333 4322, 4355 Fax: 02 4333 6976 USA ANDI Co. East 65 Campus Plaza Edison, New Jersey 0837 USA/Tel. : (201) 2258839 South Africa AEG (Pty) Ltd. Box 1 02 64 Kew/Johannesburg 2000 Tel. : 8069111 Syria Masri & Shami P. O. [. . . ]