User manual AEG-ELECTROLUX LN78479A

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. [. . . ] If the option selected is not possible, the indicator for the START/PAUSE button flashes in yellow. Start of the programme 1. Check whether the water inlet tap is open. The corresponding indicator lights up in red. It is normal for the programme selector to remain stationary during the cycle. Programme sequence The WASH indicator lights up when the appliance is in progress. Adding washing during the first 10 minutes 1. Press the START/PAUSE pushbutton. The corresponding indicator flashes in red. 2. The lid can only be opened around 2 minutes after the washing machine has come to a stop. 4. Press the START/PAUSE button again to continue the cycle. Modifying the programme in progress Before making any changes to the current programme, you need to pause the washing machine by pressing the START/PAUSE pushbutton. If the modification is not possible, the START/PAUSE button flashes in yellow for several seconds. If you still decide to change the programme, you must cancel the current programme (see below). 12 How to run a wash cycle Cancelling the programme If you want to cancel the programme, turn the programme selector to the OFF position. End of the programme The washing machine stops automatically ; the START/PAUSE pushbutton goes out and the END indicator goes on. The lid can only be opened around 2 minutes after the washing machine has come to a stop. 1. Position the programme dial on the OFF position : the washing machine is switched off. 4. Check that the drum is in fact empty: if any textiles remain inside, they could be damaged (shrunk) during the next wash or the colour could run onto other pieces of laundry. The amount of detergent to be used depends on the size of the load, the hardness of the water and how heavily soiled the washing is. If the water is soft, reduce the amount slightly. If the water contains lime scale (a descaler is recommended) or if the washing is heavily soiled or stained, increase the amount slightly. You can obtain information on the hardness level of water in your area by contacting your water company or other competent source. There are no restrictions on the use of powder detergents. Liquid detergents must not be used when a prewash has been selected. For cycles without prewash, they can be added either via means of a dosing ball, or in the detergent compartment. In either case, the wash cycle must be started immediately. Detergent tablets or doses must be placed in the detergent compartment of your appliance's dispenser box. For stain removal before a wash cycle, please refer to manufacturer's recommended amounts and instructions. Consumptions shown refer to the maximum temperature for each programme. 18 Technical specifications Technical specifications DIMENSIONS Height Width Depth 850 mm 400 mm 600 mm 230 V / 50 Hz 2300 W Minimum Maximum 0, 05 MPa (0, 5 bar) 0, 8 MPa (8 bar) Type 20x27 LINE VOLTAGE / FREQUENCY POWER CONSUMPTION WATER PRESSURE Connection to water supply This appliance conforms to the CEE 89-336 directive concerning the limiting of radio-electric interference and the 2006/95/CE directive concerning electrical safety. Care and cleaning 19 Care and cleaning Unplug the appliance before cleaning. Descaling the appliance It is not generally necessary to remove limescale from the appliance if the detergent product is properly dosed. [. . . ] The appliance can also be damaged through physical contact. Unpacking 1. Make it do a quarter turn on one of the corners to remove the transport base. 3. Open the lid of the appliance and remove the red block. 4. Remove the plastic film. Installation 27 5. [. . . ]