User manual AEG-ELECTROLUX LTH37320

[. . . ] Switching machine on / switching light on . Opening loading door / filling laundry . Putting in extra items or taking items out before end of programme . Drying cycle complete / removing laundry . [. . . ] It is best to use a damp hand for this purpose (refer to "Cleaning and maintenance" section). Turn the programme selector to OFF (AUS). After each drying cycle ­ clean the micro-fine filter and fine strainer, ­ drain the condensate tank (refer to the "Cleaning and maintenance" section). Close loading door. 3 15 Cleaning and maintenance Cleaning fluff filter To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. 1 Caution!Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Use a damp hand to clean the micro-fine filter, which is built into the lower part of the loading aperture. 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 16 3 Clean the entire filter area 3 The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. It is best to use a brush or to rinse thoroughly with a shower head. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). The dryer will not operate if the HEAT EXCHANGER (WÄRMETAUSCHER) indicator is still lit. Never operate the dryer without the heat exchanger. 19 3 1 Cleaning the drum 1 3 Caution!Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing 1 Caution!Do not use furniture cleaners or aggressive cleaning agents to clean the machine. [. . . ] Disconnect cable connector from cover G. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. On the other side, insert the cable connector in cover G, insert cover and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. [. . . ]