User manual AEG-ELECTROLUX LTH500RE

[. . . ] Useful tips and hints Environmental information 2 Contents Operating Instructions. Switching machine on / switching light on . Opening loading door / loading laundry . Removing laundry or loading laundry when necessary . [. . . ] Pour condensed water out into a sink or other suitable container. Slide outlet connections in and refit water reservoir. If the programme has been interrupted as a result of the water reservoir being full: Press the START/PAUSE button to continue the drying cycle. The water reservoir has a volume of approx. This is sufficient for around 6kg of laundry which has previously been spun at 800 revolutions/minute. The condensed water can be used as distilled water, e. g. with a coffee filter) to remove any residue and small pieces of fluff. 17 Cleaning heat exchanger 1 If the HEAT EXCHANGER display is illuminated, the heat exchanger needs to be cleaned. Caution!Operating when the heat exchanger is clogged with lint can damage the dryer. To do this, press the release button located beneath the loading aperture and open the base door to the left. Remove lint from the inside of the door and the heat exchange chamber. Turn both lock washers inwards. 1 5. Residue on inside surface of Clean inside surface of drum drum or drum ribs. Conductance of water at installation site differs from standard setting of machine. Re-programme standard setting for degree of drying (see `Programming options' section). Fine strainer not in place Install fine strainer and/or Loading door does not and/or large mesh filter not snap large mesh filter into close. place. 20 Problem When pressing a button, the corresponding button flashes several times. Programme inactive, EMPTY WATER display illuminated. Drying cycle ends shortly after programme starts. END display illuminated. Possible cause Remedy Washing protection. After the start of the programme, Turn the programme knob to the option can no longer be OFF. Turn programme selector to LIGHT or to any programme. Empty condensate tank, then start programme with START/ PAUSE button. Condensate tank is full. Select time programme or Not enough washing loadhigher drying level (e. g. INTENed or washing loaded is too SIVE DRY instead of STORAGE dry for selected programme. [. . . ] displacement length: 3m 28 Warranty conditions Great Britain Standard guarantee conditions We, AEG, undertake that if within 12 months of the date of the purchase this AEG appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our discretion repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: · The appliance has been correctly installed and used only on the electricity or gas supply stated on the rating plate. · The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's operating and maintenance instructions. · The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. [. . . ]