User manual AEG-ELECTROLUX LTH57360

[. . . ] LAVATHERM 57360 electronic Condenser Dryer Operating Instructions Dear customer, Please read these operating instructions through carefully. Please make sure you read the safety instructions on the first pages of these operating instructions!Keep the operating instructions for future reference. Pass them on to any future owners. 1 With the warning triangle and/or by means of key words (Danger!, Caution!, Attention!), information is emphasized which is important for your safety or the correct functioning of the appliance. [. . . ] Ensure the laundry does not get caught in the door when the door is closed!This could damage the laundry! Select the drying program 0 Select the suitable drying program using the program selector (see "Program tables"). 16 Drying 0 If required, select the button SPECIAL CARE (LAGE TEMPERATUUR), AUDIBLE SIGNAL (ZOEMER). · SPECIAL CARE (LAGE TEMPERATUUR) button This program operates with reduced heat. Press the SPECIAL CARE (LAGE TEMPERATUUR) button for fabrics bearing the care symbol S. Gentle drying is advisable for heat-sensitive fabrics (such as acrylic and viscose). · AUDIBLE SIGNAL (ZOEMER) button During the crease-protection phase (immediately after the drying process), an acoustic signal is sounded at certain intervals (see "End of drying process"). 17 Drying Start the drying program 0 Press the button START/PAUSE (START/PAUZE ). You can check the progress of the drying procedure in the programme progress display. Removing laundry or loading laundry when necessary You can interrupt the drying process at any time to remove some of the laundry or to add more laundry. The laundry and the drum may be hot. 0 Remove or add more laundry. 0 Press the START/PAUSE (START/PAUZE ) button to resume the drying process. End of the drying process The cooling phase starts shortly before the end of the drying process: The heater is switched-off during this phase. After the cooling phase the END/CREASE GUARD (EINDE/ANTI-KREUK) display is illuminated. You can now remove the washing from the tumble dryer. The crease guard phase follows automatically after the drying process. For 30 minutes the drum rotates intermittently. This keeps your laundry loose and crease-free. If you have pressed the AUDIBLE SIGNAL (ZOEMER) button, an acoustic signal is sounded intermittently during this phase. You should remove the washing at the latest towards the end of the anti-crease phase to avoid creasing. Removing the laundry 0 Open the door and remove the laundry. 18 Drying Empty the water reservoir 1 Caution!The condensed water is not suitable for drinking or for use with foodstuffs. The water reservoir should be emptied completely after every drying programme. This avoids interruption of a programme when the water reservoir is full. 0 Grasp the handle flap of the water reservoir and pull-out completely. 0 Push the cover of the water reservoir to the side and pour-out the condensed water. 0 Re-insert the water reservoir into the control panel. If the drying cycle has not yet ended: 0 Press the START/PAUSE (START/PAUZE) button to resume the drying process. 3 The water reservoir has a capacity of approx. This is sufficient for a laundry load of 6 kg which has been machine spun at 800 revolutions per minute. Cleaning the door seal 0 Rub the door seal with a damp cloth. 19 Drying Clean the fluff filter To ensure efficient operation of the tumble dryer, clean the fluff filter after each drying program. [. . . ] For appliances with variable voltage settings, the switch-over diagram can be found on the cover of the connection box at the back of the appliance. 32 Special accessories Special accessories You can obtain the following special accessories from your retailer. Drainage kit With this kit (E-No. 916 019 000) you can lead the condensate directly into a drain (sink, siphon, drain grating) with a maximum feed height of 1m above the floor on which the dryer is standing (3m Length). Emptying he condensate container is then no longer necessary. You can then ignore the EMPTY WATER (RESERVOIR) indicator at the end of each program. [. . . ]