User manual AEG-ELECTROLUX LTH610WEISS

[. . . ] Switching machine on / switching light on . Opening loading door / loading laundry . Putting in extra items or taking items out before end of programme . Drying cycle complete / removing laundry . [. . . ] Turn the programme selector to OFF (AUS). After each drying cycle ­ clean the micro-fine filter and fine strainer, ­ drain the condensate tank (refer to the "Cleaning and maintenance" section). Close loading door. 3 15 Cleaning and maintenance Cleaning fluff filter To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. 1 Caution!Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Use a damp hand to clean the micro-fine filter, which is built into the lower part of the loading aperture. 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 16 3 Clean the entire filter area 3 The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. It is best to use a brush or to rinse thoroughly with a shower head. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). The dryer will not operate if the HEAT EXCHANGER (WÄRMETAUSCHER) indicator is still lit. Never operate the dryer without the heat exchanger. 1 19 Cleaning the drum 1 3 Caution!Do not use abrasives or steel wool to clean the drum. Lime in the water or cleaning agents may form a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing 1 Caution!Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. What to do if. . . ? Troubleshooting by yourself If, during operation, the dryer shows an error display (one or more displays flashing on the programme progress display), check first of all whether you can remedy the problem yourself by means of the table below. [. . . ] Unscrew door lock F, push down slightly and remove from the front of the machine. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. Transfer door lock F to the oppositeside and screw down. Fix cover G on to the other side and allow the snap-in button to lock in place. [. . . ]