User manual AEG-ELECTROLUX LTH620 WEISS

[. . . ] Switching machine on / switching light on . Opening loading door / loading laundry . Putting in extra items or taking items out before end of programme . Drying cycle complete / removing laundry . [. . . ] Use a damp hand to clean the micro-fine filter, which is built into the lower part of the loading aperture. 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 17 3 Clean the entire filter area 3 The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Press against the large mesh filter until it locks into the interlock. If the fine strainer is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. 18 Emptying the water reservoir Empty water reservoir after every drying cycle. If the water reservoir is full, an active programme will be interrupted automatically and the EMPTY WATER display will light up. In order to continue the programme, the water reservoir must be emptied. 1 Warning!The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing 1 Caution!Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. What to do if. . . ? Troubleshooting by yourself If, during operation, the dryer shows an error display (one or more displays flashing on the programme progress display), check first of all whether you can remedy the problem yourself by means of the table below. If you cannot solve the problem: Switch the machine off and on again. If the error display is still shown, please contact your local Service Force Centre and inform about flashing displays. Problem Possible cause Remedy Mains plug is not plugged in Plug in at mains socket. Check or fuse is not working cor- fuse in fuse box (domestic inrectly. Close loading door. Have you pressed the START/ Press the START/PAUSE button PAUSE button?again. 21 Problem Possible cause Remedy Select a different programme the next time you dry (see Wrong programme selected. "Overview of programmes" section). [. . . ] Suplova 7 10000 Zagreb Tel. : 1 61 19512 Fax: 1 61 19513 New Zealand Monaco Corporation Ltd. 10 Rothwell Avenue Albany - Auckland 4399 Auckland 1 New Zealand Tel. : 00 64-92 59 11 11 Fax: 00 64-92 59 11 12 Syria WATTAR CO. Box 36109 Mazzeh - Damascus Direct Phone: 00963116132649 Fax: 00963116119537 Iran ARIAN International Development Co. AEG Showroom Shariati, Balatar as Safar Teheran / Iran Phone No. [. . . ]