User manual AEG-ELECTROLUX LTH7021TK

[. . . ] LAVATHERM 7021 TK ELECTRONIC Condensation dryer User Information Dear customer, Please read this User Information carefully and keep it to refer to at a later date. Pass this User Information on to any subsequent owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Notes that concern your personal safety. Attention: Notes that show how to avoid damage to the appliance. Useful tips and hints Environmental information 2 Contents Instructions for use . [. . . ] If the fine strainer is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. 17 Emptying the condensate tank Empty condensate tank after every drying cycle. If the condensate tank is full, an active programme will break off automatically and the EMPTY WATER (BEHÄLTER) display will light up. In order to continue the programme, the condensate tank must first be emptied. 1 Warning!The condensate is not suitable for drinking or for preparing foodstuffs. Pull drawer containing condensate tank out all the way (1). Pull out condensate tank's outlet connections (2). 3 3 2. Pour condensate out into basin or other suitable container. Slide outlet connections in and refit condensate tank. If the programme has been interrupted as a result of the condensate tank being full: Press the START/PAUSE button to continue the drying cycle. The condensate tank has a volume of approx. This is sufficient for around 6kg of laundry which has previously been spun at 800 revolutions/minute. The condensate can be used as distilled water, e. g. However first filter the condensate (e. g. with a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger 1 If the HEAT EXCHANGER (WÄRMETAUSCHER) display is illuminated, the heat exchanger needs to be cleaned. Operating when the heat exchanger is clogged with lint can damage the dryer. This also increases energy consumption. 18 1. To do this, press the release button located beneath the loading aperture and open the base door to the left. Remove lint from the inside of the door and the heat exchange chamber. Turn both lock washers inwards. 1 5. Use the handle to pull the heat exchanger out of the base and carry it horizontally to prevent any remaining water from spilling. To empty the heat exchanger, hold vertically over a washing-up bowl. 3 Caution!It is best to use a brush or to rinse thoroughly with a shower head. [. . . ] Insert loading door and hinges into recesses on the front of the machine and screw down. Note regarding contact protection: The machine is only secure for operations again once all plastic parts have been inserted. 27 Special accessories The following special accessories are available from your Service Force Centre or your specialist dealer: Intermediate installation kits for stacked washer and dryer: These intermediate installation kits can be used to arrange the dryer and an automatic AEG-Electrolux washing machine (60cm wide, front loading) as a space-saving washer/dryer stack. The automatic washing machine is at the bottom and the dryer is at the top. Two versions can be supplied: ­ without stacker plate 916 019 102 ­ with extractable stacker plate 916 019 103 Installation kit for external condensate drain Installation kit (125 122 510) for direct draining of condensate into a basin, siphon, gully, etc. [. . . ]