User manual AEG-ELECTROLUX LTH730

[. . . ] Switching on the appliance for the first time - setting the language. 5 5 6 7 8 8 8 9 9 9 Programme overview . Switching machine on / switching light on . Opening loading door / filling laundry . [. . . ] 17 Drying cycle complete / removing washing If the audible signal is set, at the end of the programme a 4x signal sounds and the display alternates between the messages "ANTICREASE", "PLEASE EMPTY THE TANK" and "PLEASE CLEAN THE FILTERS" . The drying cycle is automatically followed by a anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out towards the end of the anti-crease phase at the latest to prevent creases from forming. ) 1. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose (see "Cleaning and maintenance" section). After each drying cycle ­ clean the micro-fine filter and fine filter, ­ drain the condensed water container (see section "Cleaning and maintenance"). Close door. 3 Setup The special functions that can be set under Setup remain permanently stored independent of each drying cycle ­ even after the appliance has been switched off or the mains plug has been removed from the socket. Memory 1, 2, 3 Programme combinations can be stored at programme knob positions MEMORY 1, 2, 3 and can then be selected using the programme knob. To do this, the desired programme combination is first put together and then stored. 18 Setting the Memory Example: Programme posi12. 45 EXTRA DRY tion MEMORY 1 is to be giv15. 16 en the following programme Cycle end at dýaýa aýaýaýSýaýaýaýaýa combination: COTTONS EXTÜR U/MIN OPTION OK ZEIT TRA DRY (BAUMWOLLE EXPORTE T/MIN. Press the OK button to confirm the setting. The icon changes to the next special function. Press the OPTION button repeatedly until the exit icon is displayed. Turn the programme knob to any programme and press the OPTION button repeatedly, until the ú SETUP symbol flashes. Press the OPTION button re12. 45 peatedly, until LANGUAGE is Language: ENGLISH shown in the display. aýaýa aýaýaýaýBýaýaýaýa 4. Press the OK button. PORTE OPTIONS OK TEMPS T/MIN. Press the OPTION button repeatedly, until the desired language appears in the display, e. The icon changes to the next special function. Press the OPTION button repeatedly, until the initial display is shown. TÜR U/MIN OPTION OK ZEIT Clock 1. [. . . ] Disconnect cable connector from cover G. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. On the other side, insert the cable connector in cover G, insert cover and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the machine and screw down. [. . . ]