User manual AEG-ELECTROLUX LTHDIAMANT309

[. . . ] Switching machine on / switching light on . Opening loading door / loading laundry . Putting in extra items or taking items out before end of programme . Drying cycle complete / removing laundry . [. . . ] Turn the programme selector to OFF (AUS). After each drying cycle ­ clean the micro-fine filter and fine strainer, ­ drain the condensate tank (refer to the "Cleaning and maintenance" section). Close loading door. 3 15 Cleaning and maintenance Cleaning fluff filter To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. 1 Caution!Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Use a damp hand to clean the micro-fine filter, which is built into the lower part of the loading aperture. 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 16 3 Clean the entire filter area 3 The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Clean the inside of the door, the fluff filter chamber and the rubber seals of fluff. 5. Remove fluff from the fluff filter on the floor of the base with a damp hand. 19 1 6. To clean the filter mat: Remove filter mat from filter housing. To do this, press the pressure points on the sides and pull the filter mat and frame up and out of the housing. Take the filter mat out of the frame and wash it by hand or use a vacuum cleaner, when it is has dried out. Fluff, which has become stuck in the filter mat and has not been removed by washing, does not affect the function. Insert the filter mat in the frame and then insert with the frame into the filter housing. Important: The filter mat must engage tightly with the frame. Check that the mat is sitting snuggly in the frame, especially after inserting it into the filter housing. 3 9. once every 6 months, remove the fluff from the heat exchanger using the sponge supplied. When doing this, please use rubber gloves. [. . . ] Unscrew door lock F, push down slightly and remove from the front of the machine. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. Transfer door lock F to the oppositeside and screw down. Fix cover G on to the other side and allow the snap-in button to lock in place. [. . . ]