User manual AEG-ELECTROLUX LUX CAG1500

[. . . ] Complete, Easy To Read INSTALLATION AND OPERATING INSTRUCTIONS SMART TEMP ELECTRONIC THERMOSTAT PM 4. Route the wires through the hole below the terminal block. Position the base for best appearance (to hide any marks from an old thermostat). Attach the base to the wall with the two screws provided. CONNECTING THE WIRES 5. [. . . ] The HEAT or COOL set temperature will be displayed on the right side of the display. The start time for the displayed period will flash to show that this may be changed. Use the UP/DOWN arrow keys to change the start time for this period. One period ends at the start time of the next period. The beginning of that period may not be any closer to the beginning of the next period than one 15 minute increment. Press NEXT to accept the displayed start time and advance to edit the SET TEMPERATURE. Use the UP/DOWN arrow keys to change the flashing HEAT or COOL set temperature to the temperature you desire. Press NEXT to accept the displayed set temperature and advance to edit the start time for the next period. Repeat for each of the four periods per day. The table pictured on the right is also OPEN CLOSE printed on the circuit board. The closed or J4 ELECT GAS shorted position is that which covers both a J3 2MIN 5MIN jumpers pins. To prevent its loss, a jumper F C J2 may be placed over one pin only for the J1 24HR 12HR open positions. After settings have been changed, press S8, the HARDWARE RESET button for the changes to take effect. See HARDWARE RESET THERMOSTAT LOCATION On replacement installations, mount the new thermostat in place of the old one unless the conditions listed below suggest otherwise. On new installations, follow the guidelines listed below. Locate the thermostat on an inside wall, about 5 ft. (1. 5m) above the floor, and in a room that is used often. Do not install it where there are unusual heating conditions, such as: in direct sunlight; near a lamp, television, radiator, register, or fireplace; near hot water pipes in a wall; near a stove on the other side of a wall. Do not locate in unusual cooling conditions, such as: on a wall separating an unheated room; or in a draft from a stairwell, door, or window. This can lead to corrosion that may shorten thermostat life. Do not locate where air circulation is poor, such as: in a corner or an alcove; or behind an open door. Do not install the unit until all construction work and painting has been completed. FAN COOLING HEAT COPY BUTTON COPY will copy the previous day's Heat, Cool or Fan program into the current day and advance to the beginning of the next day. DAY PERIOD MORN HEAT COOL TIME TEMP. [. . . ] This warranty does not cover damage by accident, misuse, or failure to follow installation instructions. Implied warranties are limited in duration to one year from date of original purchase. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Please return malfunctioning or defective units to the participating retailer from which the purchase was made along with proof of purchase. [. . . ]