User manual AEG-ELECTROLUX LUX DMH110

[. . . ] Complete, Easy To Read REMOVING THE OLD THERMOSTAT 1. Switch OFF the electricity to both the furnace and air conditioner; then proceed with the following: 2. Most are snap-on types and simply pull off. Some have screws on the sides, these must be loosened first. [. . . ] While flashing, the "SAVE" temperature may be changed with the UP/DOWN buttons. After 5 seconds with no button presses, the displayed "SAVE" temperature will be used as the set temperature, and ambient temperature will be returned to the display. "SAVE" will remain visible until the "SAVE" mode is cancelled. To Adjust SAVE Temperature In "SAVE" mode "SAVE" will be visible in the display Press UP or DOWN button The save temperature will be displayed flashing. The flashing the "SAVE" temperature may be changed with the UP/DOWN buttons. After 5 seconds with no button presses, the displayed "SAVE" temperature will be used as the set temperature, and ambient temperature will be returned to the display. To Cancel SAVE Mode In "SAVE" mode, Press the SAVE button. The "SAVE" indicator will be extinguished and the comfort temperature will be displayed flashing. The flashing comfort set temperature may be changed with the UP/DOWN buttons. After 5 seconds with no button presses, the comfort temperature will be made the new set temperature, and ambient temperature will be returned to the display. Save Button HEATING ONLY SYSTEMS JUMPER PROVIDED COOLING ONLY SYSTEMS JUMPER PROVIDED 1 Stage Heat / 1 Stage Cool Electronic Digital - Non Programmable Innovative "SAVE" feature Gas / Electric Blower Option Battery Powered Setting Temperature Range 45°F to 90°F Clean, Attractive Design Easy To Install EL (Electro Luminescent) Backlight Display Large, Easy To Read Display F/C Selectable Temperature Display Adjustable Temperature Differential / Cycle Rate User Temperature Offset / Display Calibration 5/2 Minute Selectable Minimum Run/Off Time for Short Cycle / Compressor Protection On-Screen Low Battery Indicator 1 Year Warranty O B Y W RH RC G C O B Y W RH RC G C COMPLETING YOUR INSTALLATION C W R RH V 5 G C Y RC R V 5 G 7. Please review the "SETUP OPTIONS" section to configure the thermostat's options. NOTE: Before use, remove the plastic film (if present) that is protecting the LCD display screen. Install two (2) Energizer® or DURACELL® "AA" size Alkaline Batteries at this time. **For instructions on installing the batteries, see the "BATTERIES AND MAINTENANCE" section. Install your DMH110 thermostat onto its base. To do this, line up the tabs on all four corners and gently push the unit straight onto the base. Do not use unnecessary force if the body does not snap into place easily. Remove the body, line it back up and try again. 10. Turn the electrical power back ON to both your heating and/or air conditioning systems. 11. Verify that both systems (and the blower fan) are operating properly. When set to a high temperature, the heating system should provide warm air after a short time in Heat Mode. Likewise, a cooling system should provide cool air after a short time when set to a low temperature in Cool Mode. [. . . ] (1. 5m) above the floor, and in a room that is used often. Do not install it where there are unusual heating conditions, such as: direct sunlight, near a lamp, television, radiator, register, fireplace, on a wall opposite a stove, or that carries hot water pipes. Do not locate in unusual cooling conditions, such as: on a wall separating an unheated room, or in a draft from a stairwell, door, or window. Do not locate where air circulation is poor, such as: in a corner or alcove, or behind an open door. [. . . ]