User manual AEG-ELECTROLUX LUX T10-1143SA

[. . . ] Do not locate in unusual cooling conditions, such as on an outside wall, or one separating an unheated room, or in drafts from stairwells, doors, or windows. This can shorten thermostat life due to corrosion. Do not locate where air circulation is poor, such as in a corner, alcove, or behind an open door. Do not install until all construction work and painting have been completed. If you have an electric system and the blower does not operate after installation, find the factory installed yellow wire currently attached to the "Y" terminal and move it to the "A" terminal on the sub-base. [. . . ] FAN: For continuous blower operation, set switch to "ON". For automatic blower operation set fan switch to "Auto". Thermostat will then cycle the blower "on" anf "off". A thermostat can only control temperature near it. If you find that it is uncomfortable some distance away from the thermostat, change the setting in order to compensate for this. FIGURE 1 FRONT COVER FIGURE 2 BASE MOUNTING HOLE NOTE 2) TOOLS REQUIRED Wirestripper or knife, drill with 3/16" bit, screwdriver, level and a pencil. 3) REMOVING OLD THERMOSTAT Please read all instructions carefully. As you complete each step, check the adjoining square . Disconnect electricity and turn off gas to the heater. Disconnect wires from thermostat, making sure they do not fall back inside the wall. Make note of wires and to which terminals they are attached as you disconnect them. For example: "Yellow wire to terminal Y, Red wire to terminal RH, " etc. Strip insulation 3/8" from wire ends and clean off any corrosion. Loosen all screws on the old thermostat and remove it from the wall. Fill wall opening with non-combustible insulation to prevent drafts from affecting thermostat. Place new decorative wall plate (if supplied), Figure 4, over wall opening. Decorative wall plate can optionally be left off. Remove Front Cover of new thermostat by inserting a finger in the side of the thermostat and gently prying away each corner. Remove Base, Figure 2, from SubBase, Figure 3, by loosening three captive screws. Place Sub-Base, Figure 3, on wallplate over wall opening. Mark wall with pencil at mounting holes as shown in Figure 2. Now lay wallplate and Sub-Base to the side. [. . . ] Please return malfunctioning or defective units to the participating retailer from which purchase was made, along with proof of purchase. Please refer to "TECHNICAL ASSISTANCE" before returning thermostat. Purchaser assumes all risks and liability for incidental and consequential damage resulting from installation and use of this unit. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusion may not apply to you. [. . . ]