User manual AEG-ELECTROLUX LUX T20-1141

[. . . ] If adjustments are necessary, move heat anticipator pointer slightly and recheck. NOTE: Set pointer to 1. 2 for millivolt systems. Turn electricity and gas back on and set pointer on top of thermostat to desired temperature. A thermostat can only control temperature near it. [. . . ] If you find that it is uncomfortable some distance away from the thermostat, change the setting in order to compensate for this. FIGURE 1 FRONT COVER FIGURE 2 BASE MOUNTING HOLE UP SPECIFICATIONS ELECTRICAL RATING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 Vac (30 Vac Maximum) SWITCH ACTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Open Contact Switch ANTICIPATOR RATING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 15A to 1. 2A TEMPERATURE RANGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50°F to 90°F LON GE . 2 R . 1 5 ANTICIPATOR . 12 C YCLES . 3 . 4 LONG POINTER CAPTIVE SCREW INSTALLATION & OPERATION 1). THERMOSTAT LOCATION For accurate temperature control and comfort, correct location is very important. On new installations, the guidelines listed below should be followed as closely as possible. When replacing an old thermostat, install the new one in the same location unless these conditions suggest otherwise. Locate the thermostat on an inside wall about five feet above the floor, where it is easy to install and adjust. It should be in a room that is used often, such as a family room. Do not install it where there are unusual heating conditions, such as direct sunlight, close to a lamp, radio, television, radiator, register, near a fireplace, or other heat producing appliance. Also, check for hot water pipes within the wall, or a stove on the other side of the wall. Do not locate in unusual cooling conditions, such as on an outside wall, or one separating an unheated room, or in drafts from stairwells, doors, or windows. Purchaser assumes all risks and liability for incidental and consequential damage resulting from installation and use of this unit. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state. only. 4) INSTALLING NEW THERMOSTAT Place new decorative wall plate (if supplied), Figure 3, over wall opening. Decorative wall plate can optionally be left off. Remove Front Cover of new thermostat by inserting a finger in the side of the thermostat and gently prying away each corner. Place Base, Figure 2, on wall plate over wall opening. Mark wall with pencil at mounting holes as shown in Figure 2. Now lay wall plate and base to the side. [. . . ] Now lay wall plate and base to the side. Drill two holes with 3/16" bit, 1" deep. Insert plastic screw anchors into drilled holes, flush with wall surface. Bring wires through large hole in decorative wall plate and through Hole For Wires in Base. [. . . ]