User manual AEG-ELECTROLUX LUX T20-1141SA

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual AEG-ELECTROLUX LUX T20-1141SA. We hope that this AEG-ELECTROLUX LUX T20-1141SA user guide will be useful to you.

Lastmanuals help download the user guide AEG-ELECTROLUX LUX T20-1141SA.

Mode d'emploi AEG-ELECTROLUX LUX T20-1141SA

Download

Manual abstract: user guide AEG-ELECTROLUX LUX T20-1141SA

Detailed instructions for use are in the User's Guide.

 [. . . ] When replacing an old thermostat,  install the new one in the same location unless these conditions suggest otherwise. Locate the thermostat on an inside wall about five feet above the floor,  where it is easy to install and adjust.  [. . . ]  Drill two holes with 3/16" bit,  1" deep.  Insert plastic screw anchors into drilled holes,  flush with wall surface.  Bring wires through large hole in decorative wall plate and through Hole For Wires in Base.  Fasten Base loosely to wall using two mounting screws. Place a level against the bottom of the Base,  adjust until it is level and then tighten mounting screws to secure the Base. 

SPECIFICATIONS
ELECTRICAL RATING 24 Vac (30 Vac Maximum) SWITCH ACTION Open Contact Switch ANTICIPATOR RATING 0. 15A to 1. 2A TEMPERATURE RANGE 50°F to 90°F

LUX PRODUCTS CORPORATION

Mt. Laurel,  New Jersey,  08054 USA

© COPYRIGHT 2006 LUX PRODUCTS CORPORATION. ALL RIGHTS RESERVED

 Attach wires to terminal screws shown in Figure 2. (Either wire to either terminal) Push excess wire back into wall opening.  Find anticipator setting on old thermostat. Setting on new thermostat should be the same. Do this by carefully sliding the long pointer on the anticipator over the desired number. If old anticipator setting cannot be determined,  look on gas control on furnace,  or set it at . 6. During heating season,  furnace should operate about five times an hour. If adjustments are necessary,  move heat anticipator pointer slightly and recheck.  [. . . ] only. 
RECYCLING NOTICE

FIGURE 2 BASE
MOUNTING HOLE

UP

ANTICIPATOR
GE

. 2
R

. 1 5

. 12

LON

C YCLES

. 3

. 4

LONG POINTER CAPTIVE SCREW

. 5

HOLES FOR WIRES CAPTIVE SCREW

. 25

MOUNTING HOLE

This product does not contain mercury. However,  this product may replace a unit which contains mercury and should not be disposed of in the trash.  [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX LUX T20-1141SA

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX LUX T20-1141SA will begin.