User manual AEG-ELECTROLUX MC 135-W/EURO

[. . . ] General safety · Do not modify or attempt to modify this appliance. · Ensure that all coins, safety pins, brooches, screws etc have been removed before starting a washing programme. If left in washing, they can seriously damage the appliance. · Use the recommended quantity of detergent. [. . . ] "Rinse plus" option The washing machine will add one or more rinses during the cycle. This option is recommended for people with sensitive skin and in soft water areas. Temporary : Press the "Rinse plus" pushbutton. The option is only active for the selected programme. Permanent : Hold down the "Temperature" and "Option" pushbuttons for a few seconds. The option is permanently activated, even if the appliance is switched off. "Delay start" This option allows you to delay the start of a wash programme by 3, 6 or 9 hours by pressing the . "Delay start" pushbutton You can change or cancel the delayed start time at any time before you press the "Start/Pause" pushbutton by pressing the "Delay start" pushbutton again (when all indicators are off, the wash programme will start immediately). If you have already pressed the "Start/Pause" pushbutton and you want to change or cancel the delayed start, proceed as follows : · To cancel the delay start and start the cycle immediately, press "Start/Pause" and then "Delay start" . Press "Start/Pause" to start the cycle. · To change the timer delay period, you must go and reprogthrough the "Stop" position ramme your cycle. Modifying the programme in progress Before making any changes to the current programme, you need to pause the washing machine by pressing the "Start/Pause" pushbutton. If the modification is not possible, the "Start/Pause" pushbutton flashes red for a few seconds. If you still decide to change the programme, you must cancel the current programme (see below). Cancelling the programme If you want to cancel the programme, turn the programme selector to the "Stop" position . End of the programme The washing machine stops automatically, the "Start/Pause" pushbutton goes out and the light "End of cycle" comes on. The lid can only be opened around 2 minutes after the washing machine has come to a stop. Turn the programme selector to the "Stop" position. Unplug and close water inlet tap. Programmes table Programme / Type of washing Cottons (cold - 90°) : White or colour, e. g. normally soiled work clothes, bed linen, table linen, body linen, towels. Load / Time 5, 5 kg 145-155 min Possible options Rinse hold, Night silence plus, Prewash, Daily, Super quick, Rinse plus, Delay start Rinse hold, Night silence plus, Prewash, Daily, Super quick, Rinse plus, Delay start Rinse hold, Night silence plus, Prewash, Daily, Super quick, Rinse plus, Delay start Rinse hold, Night silence plus, Delay start Rinse hold, Night silence plus, Delay start Rinse hold, Night silence plus, Delay start Delay start Rinse hold, Night silence plus, Rinse plus, Delay start Synthetics (cold - 60°) : Synthetic fabrics, 2, 5 kg body linen, fab, coloured farics, non-iron shirts, 85-95 min blouses. Delicates (cold - 40°) : For all delicate materials, for example curtains. [. . . ] The exterior Use warm soapy water to clean the exterior of the appliance. Never use alcohol, solvents or similar products. Dispenser box To clean, proceed as follows : 3 4 Water inlet filters To clean, proceed as follows : 1 1 2 Drainage filter Clean the filter located at the base of the appliance regularly : 1 2 Operating Problems Numerous checks were carried out on your appliance before it left the factory. However, should you notice a malfunction, please refer to the sections below before contacting the after-sales service. electrolux 7 Problems The washing machine doesn't start or doesn't fill: Causes · the appliance isn't plugged in correctly, the electrical installation isn't working, there is a power failure, · the lid of your appliance and the drum shutters aren't closed firmly, · the programme start command hasn't been properly selected, · the water supply has been cut off, the water inlet tap is closed, · the water inlet filters are dirty, · a red tab appears on the water inlet hose. [. . . ]