User manual AEG-ELECTROLUX MC COMBI 32 C-W

[. . . ] For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. Users must fully know the operation and safety features of the appliance. Persons (including children) with reduced physical sensory, mental capabilities or lack of experience and knowledge must not use the appliance. [. . . ] Speak to your local Service Force Centre. · The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. · If the fixing bracket is near to the terminal block, always make sure the connection cable does not come in contact with the edge of the bracket. · You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), ground leakage trips and contactors. Disposal of the appliance · To prevent the risk of physical injury or damage ­ Disconnect the appliance from the power supply. ­ Cut off the mains cable where it connects with the appliance and discard it. ­ Flat the external gas pipes if there are fitted. ­ Speak to your local authorised facilities for disposal of your appliance. INSTALLATION Warning!The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. Gas Connection Choose fixed connections or use a flexible pipe in stainless steel in compliance with the regulation in force. If you use flexible metallic pipes, be careful they do not come in touch with mobile parts or they are not squeezed. Also be careful when the hob is put together with an oven. Electrical connection · Ground the appliance according to safety precautions. · Make sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. · This appliance is supplied with a mains cable. It has to be supplied with a correct plug, able to support the load marked on the rating plate. The plug has to be fitted in a correct socket. 6 electrolux · Any electrical component must be installed or replaced by the Service Force Centre technician or qualified service personnel. · Always use a correctly installed shockproof socket. · Make sure that there is an access to the mains plug after installation. · Do not pull the mains cable to disconnect the appliance. · The appliance must not be connected with an extension cable, an adapter or a multiple connection (risk of fire). Check that the ground connection is in conformity with the standard and regulations force. · The power cable must be placed in such a way that it does not touch any hot part. [. . . ] After cleaning the hob, make sure the pan supports are correctly positioned. In order to properly place the pan supports, make sure that an arm of the pan support is positioned in correspondence with the hole placed at the base of the burner as shown in the picture. This way, the pan support will be stable and fixed. 10 electrolux these components well clean to prevent difficult lighting and check that the burner crown holes are not obstructed. Periodic maintenance Periodically speak your local Service Force Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. [. . . ]