User manual AEG-ELECTROLUX MC COMBI 625-D/EURO

[. . . ] To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. General safety · It is dangerous to alter the specifications or attempt to modify this product in any way. · This appliance is not intended for use by persons (including children) with reduced physical, sensory or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. [. . . ] Buzzer (Buzzer) When the drying cycle has finished, an intermittent audible signal will sound. By depressing button Buzzer (Buzzer) the acoustic signal is switched off in the following cases: · when selecting the programme · when depressing the buttons · when the programme selector dial is turned to another position during the programme or when you depress an option button during the cycle · at the end of the programme. Press the START/PAUSE (START/ PAUSE) button to continue the drying cycle. Drying cycle complete / removing laundry Once the drying cycle is complete, The lights ANTICREASE/END (ANTICREASE/END), filter and full tank illuminate. If the Buzzer (Buzzer) button has been pressed, an acoustic signal sounds intermittently for about one minute. The drying cycles (except from the WOOL (WOOL) programme) are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anticrease phase. (The laundry should be taken out towards the end of the anticrease phase at the latest to prevent creases from forming. ) 1. Before removing the laundry, remove fluff from the micro-fine filter. However first filter the condensate (e. g. with a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger HEAT EXCHANGER is displayed, If the the heat exchanger needs to be cleaned. Operating when the heat exchanger is blocked with fluff can damage the dryer. To do this, press the release button on the bottom of the door aperture and open the door in the plinth to the left. 2. Pour condensed water out into a basin or similar receptacle. 12 electrolux 6. To empty the heat exchanger, hold vertically over a washing-up bowl. It is best to use a brush or to rinse thoroughly with a hand-held shower. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). Clean fluff from the inside of the door and the heat exchanger front chamber. The appliance will not operate if the HEAT EXCHANGER indicator is still lit. [. . . ] The wire coloured brown must be connected to the terminal marked «L» or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely. [. . . ]