User manual AEG-ELECTROLUX MC1752E-B

[. . . ] and please pass it to any future owner of the appliance. We wish you much joy with your new appliance. OPERATING INSTRUCTIONS IMPORTANT SAFETY INFORMATION ENVIRONMENT INSTALLATION Transporting the appliance Appliance positioning Removing transport safety packaging Drying rack unpacking Electrical connection Changing door stop Special accessories PRODUCT DESCRIPTION CONTROL PANEL Control panel Display BEFORE FIRST USE PROGRAMMES USING THE APPLIANCE Sorting laundry Laundry weights Switching appliance/drum light on Laundry loading Selecting the programme 33 33 35 36 36 36 36 37 38 39 39 40 41 41 41 42 43 45 45 45 46 46 47 DRYNESS (DROOGTEGRAAD) 47 SPIN SPEED (T/MIN) 47 BUZZER (ZOEMER) 47 LONG ANTI-CREASE (ANTIKREUK LANG) 47 TIME (TIJD PROGR. ) 47 DELAY START (STARTUITSTEL) 48 Setting child lock 48 Starting the programme 48 Changing programme 48 Programme complete / Laundry unloading 48 DRYING RACK 49 CARE AND CLEANING 51 Cleaning fluff filter 51 Cleaning the door seal 52 Emptying the water reservoir 52 Cleaning heat exchanger filters 53 To clean the drum 55 Clean operating screen and housing 55 WHAT TO DO IF . [. . . ] Push snap-in button F in and down, push cover down slightly and remove from front of the appliance. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the appliance and screw down. Note regarding contact protection: The appliance is only secure for operations again once all plastic parts have been inserted. Stacking kit These intermediate installation kits can be used to arrange the dryer and a washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. the washing machine is at the bottom and the dryer is at the top. Read carefully the instructions supplied with the kit. Available from your Service Force Centre or your specialist dealer · draining kit Installation kit for direct draining of the condensed water into a basin , siphon , gully , etc. The water reservoir then no longer has to be drained, it must however remain in its intended position in the machine. Product description Fixed hose has to be on the suitable height from minimum of 50 cm to maximum of 1 m from floor level and cannot be looped. the child lock function locks all buttons and the programme dial. The child lock can be activated or deactivated by holding down the LONG ANTI-CREASE (ANTIKREUK LANG) and BUZZER (ZOEMER) buttons at the same time for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The padlock symbol appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. From left to the right, from iron dry to anti-crease icon depends on the drying cycle chosen. Current cupboard dry programme the following status icons are visible: cycle progress is marked by flashing dash under status icon. When appropriate part of drying cycle is accomplished dash becomes steady and appears flashing under next status icon. To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF and then reset the programme. The programme cannot longer be changed directly once the programme has started. The drying programme is not however affected by this (laundry protection). [. . . ] The special bulb can be obtained from your local service centre. When the appliance is switched on, the interior lighting switches itself off after 4 minutes when the door is open. These develop too much heat and may damage the appliance!Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse. [. . . ]