User manual AEG-ELECTROLUX MCD1761EM

[. . . ] and please pass it to any future owner of the appliance. We wish you much joy with your new appliance. SAFETY INFORMATION INSTALLATION INSTRUCTIONS PRODUCT DESCRIPTION OPERATING INSTRUCTIONS On and Off Automatic Switch Off The heat setting Activation and deactivation of the outer rings Automatic Heat Up Using the Timer 42 43 46 47 47 47 48 48 48 49 Starting the STOP+GO 49 Locking / unlocking the control panel 49 The child safety device 50 OffSound Control (Switching off and on the sounds) 50 HELPFUL HINTS AND TIPS 50 CARE AND CLEANING 52 WHAT TO DO IF. 52 ENVIRONMENT CONCERNS 53 Packaging material 53 Subject to change without notice For your safety and correct operation of the appliance, read this manual carefully before installation and use. [. . . ] The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), earth leakage trips and contactors. ⷠBond the supplied sealing tape onto the upper surface of the rabbet along the edges of the cut-out section. ⷠCut the sealing tape into four pieces relating to the length of the edges of the rabbet. For the four corners of the rabbet the ends of the sealing tapes must be cut into mitres. ⷠBond the sealing tape flush into the corner of the rabbet, so that no silicon compound can get under the glass ceramic when grouting. If you use a protection box (additional accessory), the protective floor directly below the appliance is not necessary. Function starts and stops the hob starts and stops the key lock or child lock Shows for which zone you set the time shows the time in minutes activates automatic heat-up starts and stops the roasting zone Shows the heat setting to set the heat setting increases or decreases the time selects the cooking zone Function starts and stops STOP+GO starts and stops the outer rings OptiHeat Control (3 step Residual heat indicator) : continue cook / stay warm / residual heat. OptiHeat Control (3 step Residual heat indicator) Touch for 1 second to start or stop the appliance. You do not set the heat setting after you activate the appliance. ⷠYou spill something or put something on the control panel for more than 10 seconds, (a pan, a cloth, etc. ⷠSelection of the cooking zone (if more than 1 cooking zone operate):touch again and again until the indicator of a necessary cooking zone comes on. ⷠStarting the CountUp Timer:touch of the timer comes on. When the indicator of the cooking zone flashes slower, the time counts up, display switches between and time elapsed (minutes) · Stopping the CountUp Timer: select the cooking zone with and touch or to switch off the timer. You can use the timer as a Minute Minder while cooking zones do not operate. When the time elapses, the sound operates and 00 flashes. The heat setting that you set before comes on. it prevents an accidental change of the heat setting. Helpful hints and tips To start this function touch . The heat setting that you set before comes on. When you stop the appliance, you also stop this function. Starting the child safety device · start the hob with . [. . . ] ­ Remove after the appliance is sufficiently cool:limescale rings , water rings, fat stains, shiny metallic discolorations. Use a special cleaning agent for glass ceramic or stainless steel. Clean the appliance with a moist cloth and some detergent. At the end rub the appliance dry with a clean cloth. [. . . ]