User manual AEG-ELECTROLUX MCDUO220-D/GB

[. . . ] Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. In the event of damage, make sure that there are no ignition sources nearby and keep the room well ventilated. ⷠDo not stand on the plinth, drawers or doors or use them to support anything else. [. . . ] - The system switches over automatically about 5 seconds after the button was last pressed and displays the average cooling temperature. - You can change the temperatures in the refrigerator between 9°C and 4°C. For storing fish, you can change the NaturaFresh temperature yourself. Power supply (AC) and voltage at the operating point must comply with the details on the type plate, which is located inside the appliance on the left-hand side. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. - Do not place appliance in areas of direct sunlight or next to a stove, heater or similar object. - The energy consumption depends on the installation conditions, e. - Ensure that all food is well packed and covered for storage. - First cool warm food to room temperature before storing it. This is recommended particulary if you wish to cool large quantities of fresh food as fast as possible. Two seconds so that the temperature display goes out. ⷠDo not damage or remove the type plate on the inside of the appliance. Clean the drain hole in the refrigerator compartment with a thin object, e. Do not use steam cleaners because of the risk of injury and damage. Before cleaning always switch off the appliance. Disconnect from the mains or unscrew or switch off the fuse. The ice cubes can be removed from the tray by twisting or by holding upside down for a short time under running water. Ensure that the water can flow without hindrance through the hole above the vegetable bins. Wrap the frozen food in paper or blankets and store in a cool place. ⷠTo speed up the defrosting process put a saucepan of hot but not boiling water in the compartment. ⷠLeave the door of the appliance open while defrosting. After defrosting mop up the remaining water and clean the appliance. [. . . ] Screw the attachment bracket 5 into the predrilled holes on the appliance door using the hexagonal screw 6 . Onto the unit door through the attachment brackets: unit door Z. Lift the fitting aids 4 out to the top, turn round and insert into the adjacent openings. Screw on the attachment bracket bm in the area of the towing bracket. [. . . ]