User manual AEG-ELECTROLUX MICROMAT625EWHI611843938

[. . . ] If vacuum cleaner is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center before using. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. Do not use extension cords or outlets with inadequate current carrying capacity. Turn off all controls before unplugging. [. . . ] Keep the hose in place while storing the vacuum cleaner by extending the elastic bumper cord (Fig. ENGLISH GETTING THE BEST RESULTS CAUTION: Use `Brushroll OFF' setting for wood, tile, or other hard-surface floors. Do not use `Brushroll ON' setting for hardsurface floors, as the brush roll could damage delicate surfaces. Hard Floors : Use the bare floor brush (1). Use `Brushroll OFF' setting for wood, tile, or other hard-surface floors. Do not use `Brushroll ON' setting for hard-surface floors, as the brush roll could damage delicate surfaces. Turn off brushroll when cleaning barefloors. After connecting the power nozzle to the wand and hose, turn on the canister and the brushroll for carpet cleaning (page 6). The cleaning height can be adjusted by pressing on the height adjustment pedal located on the rear of the hood (Fig. The height indicator will change from low to medium to high as you make the adjustment. C) Use the lowest setting that still allows easy maneuvering on the carpet. Remove the cyclonic filter by pulling out the filter grip. Let it dry completely before putting it back into the dust container. Clean the foam filter every 3-4 months or when it's visually dirty. Let it dry completely before putting it back into the dust container. Put the dust container back until it clicks into place. rEPLACING THE EXHAUST FILTER (EL012B) 8. Open the filter lid by pulling the 2 rear tabs back wards and lifting up. To close the lid, insert the front hooks into the rails. Push the lid forward and press down firmly. REPLACING THE MOTOR FILTER (REF 2197012-01) Replace the motor filter when dirty. Lift out the dust container by pulling the handle straight upwards. [. . . ] Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorized Electrolux service center. Damage to the motor caused by the penetration of water is not covered by the warranty. If you can't find accessories for your Electrolux vacuum cleaner, please visit our website at www. ENGLISH THE ELECTROLUX LIMITED WARRANTY Your Electrolux cleaner is warranted to be free from all defects in material and workmanship in normal household use for a period of five years. [. . . ]