User manual AEG-ELECTROLUX MICROMAT745EDAR61

[. . . ] Then open the front cover on the machine and check that the dust bag, s-bag®, and the motor filter are in place. Fold up the carrying handle until it clicks into place. Then open the back lid on the machine and check that the exhaust filter is in place. Insert the hose until the catches click to engage (press the catches to release the hose). [. . . ] 7 Press the On/Off button with the foot to start the vacuum cleaner. 8 Adjust suction power using the suction control on the vacuum cleaner or the suction control on the hose handle. 9 A practical parking position (and at the same time a backsaving feature) when you pause during cleaning. 10 A parking position which makes it easy to carry and store the vacuum cleaner. 11 a When you want to carry the vacuum cleaner, lift the carrying handle until it clicks into place. 11b You can also carry the vacuum cleaner using the handle on the lower front edge of the machine. GETTING THE BEST RESULTS Use the nozzles as follows: Carpets: Use the carpet/hard floor nozzle with the lever in position (1). Hard floors: Use the carpet/hard floor nozzle with the lever in position (2). If you have a carpet/hard floor nozzle with two pedals ­ press the pedal on the right (3) to vacuum up animal hair, etc. Using the power nozzle 5 6 7 8 (Requires an Classic Silence equipped with a power socket. The power nozzle is delivered only with certain models, or could be bought as an accessory. Replace the insert holding the s-bag® and then close the cover. Should be done with every 5th replacement of the dust bag, s-bag® EFH12W) The filters must always be replaced with new ones and cannot be washed (except the Hepa H12* washable) 12 Fold up the carrying handle until it clicks into place. 13 Place your thumbs on the back edge of the lid and then open the lid by pulling the handle backwards and upwards with your index/middle finger. In such cases, disconnect from mains and allow to cool for 20-30 minutes. However, be careful in case the obstruction is caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to the hose caused by cleaning it. 3 To avoid deterioration of suction power, frequently clean the carpet/hard floor nozzle. The easiest way to clean it is by using the hose handle. Press each wheel-hub and draw away the wheels. Remove dust-balls, hair or other objects that may be entangled. Use the crevice nozzle to clean the wheel axles. [. . . ] replace the wheels by pressing them onto the axles. Larger objects can be accessed by removing the connection hose (press the small catches located on each side and simultaneously draw the connection tube outwards in an upright position). 11 To clean the wheels, gently lever them from their mountings and clean as necessary. 12 Replace the cover and make sure it is securely fastened. [. . . ]