User manual AEG-ELECTROLUX MICROMAT745EWHI61

[. . . ] also replace after vacuuming carpet-cleaning powder. Be sure to use only an original Electrolux s-bag® . CAUTION: Do not use before fully assembled. Telescopic wand A Hose handle release B Telescopic release (either button) 2. [. . . ] Open the Air Basket and lift out the S-Bag® by pulling the cardboard tab up. This automatically seals the S-Bag® and prevents dust and debris from leaking out. Insert a new S-Bag® by pushing the cardboard through the groove slots of the Air Basket, close the Air Basket lid, and put the Air Basket back into the cleaner. 4) Note: Be sure to replace the S-Bag® each time after vacuuming carpet-cleaning powder. Be sure to use only Genuine Electrolux S-Bag®. CAUTION: To reduce the risk of injury, unplug before servicing­the brushroll could suddenly restart. THERMAL CUT OFF The vacuum cleaner may automatically stop if there is a blockage in the nozzle, wands or hose and/or if the filter has become blocked. Disconnect the cord from the outlet and allow the vacuum cleaner to cool down for 20­30 minutes. Remove the blockage, and/ or replace the dirty filter. Use a suitable blunt implement to clear the wands and hose (Fig. However, be careful in case the obstruction is caused by glass, needles, or sharp plastic caught in the hose assembly. Place new belt around brushroll motor pulley. Place other end of belt around brushroll, insert belt end of brushroll back into case, followed by the other end. Replace brushroll cover, and snap tabs into place Note: Use only GENUINE ELECTROLUX belt 155555. Quite el cepillo motorizado, quite cualquier resto de suciedad y retire la correa usada (Fig. 13 13 ENGLISH TROUBLESHOOTING AND CONSUMER INFORMATION FRANÇAIS DÉPANNAGE ET INFORMATION DES CONSOMMATEURS ESPAÑOL SOLUCIÓN DE PROBLEMAS E INFORMACIÓN PARA EL CONSUMIDOR CAUTION: To reduce the risk of injury, unplug before servicing. TROUBLESHOOTING The vacuum cleaner does not start 1 Check that the cord is connected to the outlet. 2 Check that the plug and cord are not damaged. 3 Check for a blown fuse or tripped circuit breaker. The brushroll stops spinning 1 Turn off power. 2 Remove any obstructing objects from the brushroll. The vacuum suddenly stops working 1 Turn off power. [. . . ] To register your warranty, please visit www. Com (Canada) or fill out and return the attached warranty registration card. To obtain warranty service you must return the defective cleaner or cleaner parts along with proof of purchase to any Electrolux Authorized Warranty Station. For the location of the nearest Electrolux Authorized Warranty Station or for service information in the United States or Canada, please telephone toll free: 1-800-896-9756 You may also visit us online at www. [. . . ]