User manual AEG-ELECTROLUX MOD ETN1281H

[. . . ] ⷠSwitch the cooking zones off after each use. safety when cleaning · For cleaning, the appliance must be switched off and cooled down. ⷠFor safety reasons, the cleaning of the appliance with steam jet or high-pressure cleaning equipment is not permitted. how to avoid damage to the appliance · The glass ceramic can be damaged by objects falling onto it. [. . . ] ) Touch of both the cooking zones at the front simultaneously for 4 seconds. Switching off the child safety device Step 1. ) Touch of both the cooking zones at the front simultaneously for 4 seconds. 3The child safety device can only be switched on and off, if no heat setting is set. Overriding the child safety device The child safety device can be switched off in this way for a single cooking session; it remains activated afterwards. Control panel Switch appliance on Touch of both the cooking zones at the front simultaneously for 4 seconds. Until the appliance is next switched off, it can used as normal. After switching off the appliance, the child safety device is active again. Heat setting or a function must be set within approx. 10 seconds, otherwise the appliance automatically switches itself off. If after switching on the cooking surface, a heat setting is not set for a cooking zone within approx. Switch the appliance on again Acoustic signal sounds when appliance is switched off The residual heat indicator is not displaying anything The control panel is wholly or part- Remove objects. The cooking zone was only on for a short time and is therefore not hot If the cooking zone is supposed to be hot, call the Customer Service Department. Do not place any objects on the control panel Acoustic signal sounds and appli- The On/Off sensor field has been ance switches itself on and then covered up, e. By a cloth off again; after 5 seconds another acoustic signal sounds is lit Overheating protection for the cooking zone has been triggered Automatic switch off has been trig- Switch off the cooking zone. Gered Switch the cooking zone on again and number are displayed Electronics fault Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, is displayed again, call the customer service department If you are unable to remedy the problem by following the above suggestions, please contact your local Service Force Centre. Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs. 3 If the appliance has been operated incorrectly, the engineer's visit will be chargeable, even during the warranty period. The packaging materials are environmentally friendly and can be recycled. On the product or on its The symbol packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. [. . . ] If this appliance's mains cable is damaged, it must be replaced by a special cable (type H05BB-F Tmax 90°C; or higher) or an equivalent type. the latter is available from the Customer Care Department. A device must be provided in the electrical installation which allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm. Suitable isolation devices include line protecting cut-outs, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors. [. . . ]