User manual AEG-ELECTROLUX N24

[. . . ] Use the slider on the cleaner to adjust suction power. Switch on/off the vacuum cleaner by pushing the ON/ OFF button. Models with remote control can also be operated by the ON/OFF button on the handle. FIL TE R S-B AG Use the + or ­ rocker button on the cleaner to adjust suction power. [. . . ] Motorized nozzle gives the best dust pick-up and deep cleaning of carpets through the rotating brush roller agitating the carpet. Do not leave the motorized nozzle stationary with brush roller on. Models with mechanical indicator: The dust bag, s-bag®, must be replaced at the latest when the indicator window is completely red. Models with digital display: Replace / clean* the exhaust filter when the "filter" indicator is illuminated. Models with mechanical suction power control: Replace / clean* the exhaust filter at every 5th replacement of the dust bag, s-bag® Modeller med mekanisk regulering af sugeeffekten: Udskift/rengør* udsugningsfilteret ved hver 5. * Washable filters only * Kun vaskbare filtre gre 8 Replacing the dustbag, s-bag® / Udskiftning af støvsugerposen s-bag® A B Open the dust compartment cover. A Pull the cardboard to remove the s-bag® from the insert. This automatically seals the s-bag® and prevents dust leaking out. B Insert a new s-bag® by pushing the cardboard right into the end of the groove in the insert. b Isæt en ny s-bag® ved at skubbe papstykket helt i bund i rillerne. Always change the s-bag® when the indicator signal is illuminated even if the s-bag® is not full (it may be blocked) and after using carpet cleaning powder. Use the hose handle to clean the nozzle. Ita nor ned por esp Change battery when light indicator is not responding when pressing any button. Batteries must be removed from the appliance before it is scrapped and are to be disposed of safely. Remote handle with motorized nozzle system DO NOT have any batteries or light indicator, so DO NOT try to open the motorized handle. The vacuum cleaner does not start · Check that the cable is connected to the mains. Check that the plug and cable are not damaged. The s-bag® indicator light is illuminated (only at specific models) · If you have already changed the s-bag®, change the motor filter. The filter indicator light is illuminated (only at specific models) · Change the exhaust filter The cleaner stops The cleaner might be overheated: disconnect it from the mains; check if the nozzle, tube or hose are blocked. Let the cleaner cool down for 30 minutes before plugging it in again. If the cleaner still does not work, contact an authorized Electrolux service centre. However, be careful in case the obstruction has been caused by glass or needles caught inside the hose. [. . . ] Always disconnect the plug from the mains before cleaning or maintaining the appliance. Never use the vacuum cleaner without its filters. caution This appliance contains electrical connections: · Never vacuum any liquid substance · Do not immerse in any liquid for cleaning · Disconnect the appliance from the mains when not in use · The hose should be checked regularly and must not be used if damaged. The above can cause serious damage to the motor, which is not covered by the warranty. [. . . ]