User manual AEG-ELECTROLUX NF4046

[. . . ] You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time. Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. electrolux. com Register your product for better service: www. electrolux. com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. electrolux. com/shop CUSTOMER CARE AND SERVICE We recommend the use of original spare parts. [. . . ] Refer to the Safety chapters. 4. 1 Ignition of the burner WARNING!Be very careful when you use open fire in kitchen environment. Manufacturer decline any responsibility in case misuse of the flame ENGLISH 7 Always light the burner before you put cookware. Turn the control knob counterclockwise to the maximum position ( ) and push it down. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple to warm up. If not, the gas supply will be interrupted. If after some tries the burner does not light, check if the crown and its cap are in correct positions. E) Thermocouple WARNING!Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. If the burner accidentally goes out, turn the control knob to the off position and try to light the burner again after minimum 1 minute. To remove the dark marks, do as follows: – Prepare a mixture of 50% water and 50% wine vinegar. – Soak the crowns in the mixture for no longer than 10 minutes. – Rinse the crowns in water to remove the mixture and dry them carefully. • Wash stainless steel parts with water, and then dry them with a soft cloth. • The pan supports are not resistant to washing in a dishwasher. • When you wash the pan supports by hand, be careful when you dry them as the enamel coating occasionally can have rough edges. If necessary, you ENGLISH 9 can remove stubborn stains with a paste cleaner. • After you clean the pan supports, make sure that they are in correct positions. • Make sure that the arms of the pan supports are in the centre of the burner for the burner to operate correctly, . • To prevent the hob top from damage, be very careful when you replace the pan supports . After cleaning, dry the appliance with a soft cloth. [. . . ] The cable should be guided by means of clamps fixed to the side of the cabinet, in order to avoid any contact with the equipment beneath the cooktop. • Make sure that there is access to the mains plug after the installation. A B C D E Electrical Requirements Permanent electrical installation must agree with the latest I. E. E. Regulations and local Electricity Board regulations. For your own safety the installation must be done by a qualified electrician (e. g. [. . . ]