User manual AEG-ELECTROLUX OEKOLAVAMAT1271

[. . . ] If your old appliance has a snap-lock or bolt-type door catch, please make it completely ineffective before storing the appliance away or sending it for environmentally friendly disposal. You will thus ensure that children at play cannot lock themselves in, which could even put their lives in danger. Please also make sure that the pipes in your old appliance are not damaged before being taken away for proper, environmentally friendly disposal. We recommend that you read the following instructions before using the appliance for the first time, as this is the only way in which you can make full use of all its advantages. [. . . ] If the appliance is installed under a continuous worktop, the plug socket should be provided as in Fig. 3. Adjustable feet for a working height of 85 /86 cm Fig. 1 Your appliance is fitted as standard with four adjustable feet, so that you can compensate for any unevenness in the floor by turning them inwards or outwards. If the appliance is to be installed underneath a continuous work-top, all four feet will need to be turned to the position (A) which place the appliance as low down as possible. Special accessories adjustable feet for a working height of 90/91 cm Fig. 2 If the appliance is to be installed with a working height of 90/91 cm, four adjustable feet (B) 6 cm long must be bought as special accessories and screwed into place. The standard feet can be left in the low-down position (A). Electrical connection WARNING - THIS APPLIANCE MUST BE EARTHED Please ensure that the voltage and current indicated on the rating plate agree with the voltage of your electricity supply. If your appliance has been equipped with a mains lead with a moulded-on type plug, you must comply with the following regulations: The plug moulded on to the cord incorporates a fuse. For replacement, use a 13 amp BS 1362 fuse. Only ASTA approved or certified fuses should be used. The fuse cover/ carrier must be replaced in the event of changing the fuse. The plug must not be used if the fuse cover/carrier is lost. A replacement cover/carrier must be obtained from an electrical goods retailer. Unscrew the holding bracket (H) and keep it in a safe place. Variable work-top adjustment Fig. 10 The variable work-top permits the front face of the appliance to be lined up with absolute precision with the fronts of the other appliances or kitchen cabinets. To this end, the work-top can be adjusted forwards in two stages to a maximum of 16 mm. Loosen the two Phillips screws (F) on the left and the right. Push the work-top forwards to the required position. If it is necessary to bring the work-top more than 8 mm forwards, take the screws (F) out, push the work-top forwards, and insert the screws into the second group of holes (see lower picture). Fastening to a continuous work-top Fig. 6 To install the appliance underneath a continuous work-top, fix it on the left and the right underneath the work-top with a fixing screw (F) passing through the elongated slot in the door bearing. The screws taken out when the work-top was removed can be used for this purpose. Changing over the door hinges Figs. 7 to 9a Before you connect the appliance to the power supply you should check whether the door should close to the right (as delivered) or should better be changed over to the left if the position and ease of 14 GB Before starting up Like all new appliances, your new refrigerator will have a certain odour of its own, so it is advisable to clean the interior and all the internal fittings (see: "Care and cleaning" ). Correct storage Fig. 12 1 = Butter, cheese 2 = Eggs, mustard and tomato sauce etc. To fit it at a different level, reverse the procedure. VARIO glass storage shelf *) If, for instance, you intend to store bottles, cans, or jars in an upright position, please push the front half of the VARIO storage shelf underneath the rear half. This will provide space for tall items to be stored on the next shelf below it. *) not supplied with all models. 15 GB Care and cleaning Your refrigerator should be cleaned at regular intervals. [. . . ] If the defect lies in the appliance, please inform the nearest Service Centre. In order to avoid unnecessary travel or expense, please state: - Model description - E-number - F-number of your appliance. You will find these data on the rating plate on the left inside your appliance. We recommend that you enter them here: Model description . [. . . ]