User manual AEG-ELECTROLUX OEKOS.1673-4TK

[. . . ] ÖKO-SANTO SUPER Tisch-Kühlautomat Réfrigérateur automatique table top Tafelmodel koelkast Automatic Refrigerator Gebrauchsanweisung Mode d'emploi Gebruiksaanwijzing Operating Instructions Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Lift the work-top slightly, push it F about 20 mm towards the rear, and lift it off upwards (G). Unscrew the holding bracket (H) and G keep it in a safe place. H AEG56 62 Mounting under a continuous worktop If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel. A AEG96 Rehingeing the door The side at which the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires. When changing the side at which the door opens, the appli ance may not be connected to the mains. Tilt the appliance slightly towards the rear and drop it securely. A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut-off plug is disposed of safely. Plug socket The plug socket necessary for connection of your appliance to the electricity supply should be positioned so that it is possible to pull out 130 the appliance plug. If your appliance is installed under a continuous worktop, the plug 300 socket should be provided as shown. A concealed protective contact plug socket requires 10 A/16 A fusing. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). AEG44 65 Starting up and temperature regulation Insert the plug of the connection lead into the plug socket with protective earth contact. When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature selector knob is located on the RH side of the refrigerator compartment. Turning clockwise in direction , , 1": Refrigerating unit on, the latter then operating automatically. Setting , , 1" means: Hightest temperature, warmest setting. Setting , , 6" (end-stop) means: Lowest temperature, coldest setting. At a low ambient temperature of around 16°C, setting , , 1" should be selected. At ambient temperatures of around 25°C, select setting , , 2". If you require a lower temperature, select setting , , 3" or , , 4". on hot summer days) and a cold setting on the temperature regulator (position"5" to "6") can cause the compressor to run continuously. Reason: when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. The fridge will not be able to defrost since automatic defrosting of the fridge is only possible when the compressor is not running (see also "Defrosting" section). The result is the build up of a thick layer of frost on the fridge rear wall. [. . . ] Please look in the "Installation location"section. Please look in the "Changing the Light Bulb". Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. At the same time shape the warmed door seal by hand such that it sits correctly. [. . . ]