User manual AEG-ELECTROLUX OEKOS.2183BLUE

[. . . ] Kühl-Gefrierkombination Refrigerateur-congelateur Tweedeurs-koelkast Fridge-freezer Gebrauchsanweisung Mode d'emploi Gebruiksaanwijzing Instruction booklet 2222 019-12 CONTENTS Warnings . Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page . page 29 30 30 30 30 30 31 32 32 32 32 32 32 33 33 33 34 34 34 35 35 35 35 35 Positioning . Rear spacers . Electrical connection . . Operation . Temperature regulation . [. . . ] Appliance positioned without overhanging kitchen units (see Fig. Attention: keep ventilation openings clear of obstruction. Two adjustable feet at the cabinet base allow accurate levelling of the appliance. 1 100 mm A 45° D060 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/ 308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A 10 mm B 10 mm NP004 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 30 Door reversibility Before carrying out any work, remove the plug from the power socket. To change the opening direction of the doors proceed as follows: Remove the lower hinge (3), the pin (1) and the support foot (2). Remove the centre hinge and slide the top door off pin (5); unscrew pin (5) and refit it on the opposite side. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. Refit the top door and the centre hinge (H) on the opposite side. Refit the lower hinge (Turning it 180°), the pin (1) and the support foot (2) on the opposite side. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. [. . . ] This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. [. . . ]