User manual AEG-ELECTROLUX OEKOS.2573-4KA

[. . . ] Kühlschränke ÖKO - Santo Super 2573-4 KA ÖKO - Santo Super 2373-4 KA Refrigerateur Koelkast Fridge Gebrauchsanweisung Mode d'emploi Gebruiksaanwijzing Instruction booklet 2222 016-41 CONTENTS Warnings . . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page . Page 27 28 28 28 28 28 29 29 30 30 30 30 30 31 31 31 31 32 32 32 33 33 33 33 33 Installation . Positioning Rear spacers . Electrical connection . Door reversibility Inner door reversal Use . [. . . ] Appliance positioned without overhanging kitchen units (see Fig. Attention: keep ventilation openings clear of obstruction. Two adjustable feet at the cabinet base allow accurate levelling of the appliance. Fig. 1 PR153 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. 100 mm A 10 mm B 10 mm This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. NP007 This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 28 Door reversibility Before carrying out any work, remove the plug from the power socket. To change the opening direction of the doors proceed as follows: Remove the clip-in ventilation grille (D). Remove the bottom hinge (E) by unscrewing the two fixing screws. Slide the door off pin (5); unscrew pin (5) and refit it on the opposite side. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. Refit bottom hinge (E) on the opposite side, using the two screws previously removed. Remove blanking cover (F) from ventilation grille (D) by pushing it in the direction of the arrow and refit it on the opposite side. Refit ventilation grille (D), clipping it into place. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. Attention After completion of the door reversibility operation, verify that the door gasket is adherent to the cabinet. If the ambient temperature is cold (i. e. [. . . ] No further food to be frozen should be added during this period; 31 Thawing (Only for ÖKO Santo Super 2373-4 KA model) Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. Freezer (Only for ÖKO Santo Super 2373-4 KA model) The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. [. . . ]