User manual AEG-ELECTROLUX OEKOS.2842-4I

[. . . ] Integrierbare Einbau Kühl-Gefrierkombination Fridge-freezer Réfrigérateur-congélateur Koel-vriescombinatie Gebrauchs- und Montageanweisung Operating instructions Mode d'emploI Gebruiksaanwijzing 2222 032-12 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 13 14 14 14 14 14 17 17 17 17 17 17 18 18 18 19 19 19 20 20 20 20 20 Electrical connection . Cleaning the interior . Instructions for totally built-in appliances Door reversibility . . Operation . Temperature regulation . [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. Instructions for totally built-in appliances Door reversibility (Fig. 1) P P A 1 P1 P1 D544 Fig. 1 Right-hand opening Remove pins (P) and (P1). Left-hand opening Remove (P) from both sides and also remove the door. Remove centre hinge (A) and refit it on the opposite side. Refit the door and (P) on the left-hand side and remove (P1) from the right-hand side. 14 Recess dimensions Height Depth Width 1780 mm 550 mm 560 mm For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. 50-min. 5 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. D Fasten the appliance with 4 screws provided C D723 in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. 6 Press in the joint covers between the appliance and the kitchen unit. min. 3 Push appliance into housing until stop strip (A) touches the kitchen unit. D724 D023 Fig. 7 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 4 If after having carried out the previously A described operation there is still some space left between the appliance and the kitchen unit, fit the trimming D265 provided together with the appliance on the stop strip (A). B D726 15 Fig. 8 Position the runners (H) at the H top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the 20m m position of the external holes. After preparing D094 the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. 9 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. D E D734 Fig. 11 If the appliance is fixed to the side of the kitchen unit, simply slacken the screws in fixing brackets (D), move the brackets as shown in Fig. Then fit cover (E). 8mm PR34 Fig. 10 Remove the little plates and make the holes with a diam. [. . . ] Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: pull out the plug from the wall socket or turn the thermostat knob to the «O» setting; remove any stored food, wrap it in several layers of newspaper and put it in a cool place; leave the door open, and insert the plastic scraper in the appropriate seating at the bottom centre, placing a basin underneath to collect the defrost water; Fig. 17 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. [. . . ]