User manual AEG-ELECTROLUX OKO-S-3153-6DT

[. . . ] - 89/336/EEC of 03. 05. 1989 (including Amendment Directive 92/31/EEC) - EMC (Electromagnetic Compatibily) Directive. Before starting up, we recommend you to read the following instructions for use, since only by doing so can you benefit from all the advantages offered by your freezer. These instructions for use are intended for several technically comparable models with different equipment. Please only take note of the instructions that apply to your particular version. [. . . ] Fit the door mounting pin of the door mounting (1) into the left-hand pivot hole and screw the door mounting in with the screws (K). Transfer the separate fitment (L), of the plinth panel from left to right and press the plinth panel back into the panel holders. Refit it on the opposite side after having pierced the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. Removing the worktop Fig. 5 After removal of the worktop of your table-top freezer the appliance can be installed under a continuous worktop. P ro c e e d a s d e s c r i b e d h e re : U n s c re w t h e cross-head screws (F) on the right and the left. Lift the worktop slightly, move it about 5 mm towards the rear, and lift it out upwards (G). Unscrew the worktop holders (H) and keep them in a safe place. Mounting under a continuous worktop Fig. 6 If the appliance is to be installed under a continuous worktop, it needs to be fastened in place on the right and the left with a fastening screw (F) which passes through the elongated hole of the door mounting. The mounting screws of the removed worktop can be used for this purpose. 16 GB Cleaning before starting up In common with all new appliances, your freezer will emit a specific odour when new. It is therefore advisable to clean the interior of the freezer and all accessories before use (see also "Defrosting and cleaning"). Hint for test centres Filling plans for determination of freezing capacity and warm-up time may be ordered direct from the manufacturer. The cold-accumulator is positioned at the front and in the event of a power failure, a fault, or a removal, postpones the moment when the interior warms up to an impermissible level by several hours. It can also be used temporarily for cooling an insulated picnic-bag. For refreezing it, see the instruction on "Before starting up". Berries can be pre-frozen in this freezer drawer, and then packed in portion-sized packs in the other freezer compartments. The drawer can also be used for storing small frozen items, e. g. herbs. Taking out the freezer drawers Figs. 11 and 12 The freezer drawes (2) are stable and have an antitilt feature, and are also retained at their endpositions (Fig. This assures safe and convenient insertion and removal of frozen food. To remove them, withdraw them as far as the catch, tilt them upwards, and pull them out forwards (Fig. 12) Symbols for stored food Fig. 13 Food symbols are printed on the drawers. Sort the food to be frozen according to type as much as possible, and place it in separate compartments. [. . . ] a pastry scraper (not with a knife or the like). The appliance needs not be switched off. You will avoid heavy frost formation by not leaving the door open unnecessarily long. Magnetic door seal After opening and closing the door of your freezer whilst it is in operation, you will not immediately be able to open the door again because a vacuum will have developed inside, keeping the door closed until the pressures inside and outside the door have equalised. After a few minutes you can easily reopen the door. 19 GB Switching the appliance off If your freezer is to remain unused for any length of time, it must be disconnected (unplugged) from the electricity supply. [. . . ]