User manual AEG-ELECTROLUX OPPINSTALLEN06

[. . . ] Installation Instructions READ BEFORE INSTALLING UNIT OPP5K Window Mounting Your air conditioner is designed to install in standard double hung windows with opening widths of 23 to 36 inches (584 mm to 914 mm) (FIG. 1) Lower sash must open sufficiently to allow a clear vertical opening of 14-1/2 inches (368 mm). Side louvers and the rear of the AC must have clear air space to allow enough airflow through the condenser, for heat removal. [. . . ] If you are not using the Side Panels for any reason, this pitch to the rear must be maintained!Place unit on floor, a bench or a table. There is a Left and Right Window Filler Panel - be sure to use the proper panel for each side. When installed the flange for securing the panel in place to the window sill will be facing into the room. FIG. Hold the Accordion Panel in one hand and gently pull back the center to free the open end. 5 has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. Slide the panel all the way in and repeat on the other side. NOTE: If storm window blocks AC, see FIG. Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. Carefully close the window behind the top rail of the unit. 2 FIG. Slide the free end ("I"section) of the panel into the cabinet as shown in Figures 3A, 3B & 4. Be sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet. FIG. 6A 3 Extend the side panels out against the window frame (FIG. 7 2 SZ000357(En) 2 10/21/2004, 10:42 AM Place the frame lock between the frame extensions and the window sill as shown (Fig. Drive 3/4" (19 mm) locking screws through the frame lock and into the sill (FIG. NOTE: To prevent window sill from splitting, drill 1/8" (3 mm) pilot holes before driving screws. 4 7 Cut foam seal and insert in the space between the upper and lower sashes (FIG. [. . . ] Keeping a firm grip on air conditioner, raise sash and carefully "rock" air conditioner backward to drain any condensate water in base of unit. Be careful not to spill any remaining water while lifting unit from window. Store parts WITH air conditioner. FIG. [. . . ]